Instruction Manual for Razor models including: W25141001002, W25141001002 Ground Force Rad Rod Electric Powered Ride, Ground Force Rad Rod Electric Powered Ride, Force Rad Rod Electric Powered Ride, Electric Powered Ride, Powered Ride, Ride

• Google Docs
• Google Drive
• Download [pdf]
• Download Optimized
• Document:
  • References

File Info : application/pdf, 4 Pages, 2.20MB

Required Tools: (Not included)
A. 5 mm Allen Wrench B. 3 mm Allen Wrench C. Phillips Screwdriver D. Long Needle Pliers

GROUND FORCE RAD ROD REAR AXLE REPLACEMENT INSTRUCTIONS
PART # W25141001002
E. Two (2) 17 mm Socket Wrenches F. 10 mm Open-End Wrench G. C Clip Pliers

WARNING
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect charger before conducting any assembly or maintenance procedures. Failure to follow these steps in the correct order may cause irreparable damage.

Step 1
Remove the flag and use a 5 mm Allen wrench to remove four (4) screws on the seat, then remove the seat.

Step 2
Use a Phillips screwdriver to remove five (5) screws on the battery rear cover.
AB

A A

B

A

B

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time. 1

Step 3
Use a Phillips screwdriver to remove three (3) screws on the battery front cover. Then remove the battery front cover after unplugging all plugs.

Step 4
Using a Phillips screwdriver, remove the screws from the chain cover and remove the cover.

Step 5
Using two (2) 17 mm Socket wrenches, loosen and remove the lock nuts from the rear wheels.

Step 6
Remove the wheels and hardware from the axle and set aside.

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time. 2

Step 7
Use a 5 mm Allen wrench and a 10 mm open-end wrench to remove two (2) bolts and lock nuts from the brake drum.

Step 8
Use a 3 mm Allen wrench to remove the set screw on the brake hub. Slide the brake drum and brake hub off from the axle.

Step 9
Using long needle pliers, remove the master link from the chain and remove the chain.

Step 10
Use a 3 mm Allen wrench to remove the set screw from the sprocket and slide it out from the axle.

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time. 3

Step 11
Use C clip pliers to take off the snap rings on both sides.

Step 12
Remove the rear axle from the frame.

Step 13
To install a new rear axle, reverse steps 1 through 12. ATTENTION: Charge battery 8 hours before using.

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time. 4



References