Invacare Birdie® EVO Mounting Instruction
Invacare® Birdie® EVO, Birdie® EVO COMPACT, Birdie® EVO PLUS, Birdie® EVO XPLUS
Installing the Wunder RS scale with SMARTLOCK®
Follow these steps to install the Wunder RS scale with SMARTLOCK®.
-
Step 1: Attach the scale to the spreader bar. Ensure correct alignment. [Checkmark symbol] indicates correct installation, [Cross symbol] indicates incorrect installation.
Diagram shows attaching the scale unit to the spreader bar, with close-ups of connection points and required tool sizes (2.5 mm and 5 mm).
-
Step 2: Connect the scale's power and data cables.
Diagram shows connecting cables to the scale unit and the patient lift's control box.
-
Step 3: Secure the scale unit.
Diagram shows securing the scale unit with fasteners.
-
Step 4: Attach the spreader bar to the patient lift arm.
Diagram shows attaching the spreader bar to the lift arm, with arrows indicating the connection points.
-
Step 5: Ensure all connections are secure. [Warning symbol] indicates a point requiring attention.
Diagram shows a close-up of a connection point with a warning symbol, indicating the need for careful assembly.
-
Step 6: Final check of the scale and spreader bar assembly.
Diagram shows the assembled scale and spreader bar attached to the patient lift.
-
Step 7: Connect the scale to the lift's control system.
Diagram shows connecting the scale's wiring to the patient lift's control system.
This instruction is an extract from the service manual. The service manual is available in other languages and can be downloaded from the Invacare website. For more information, contact the Invacare representative in your country.
Installing the Wunder RS scale with a fixed spreader bar
Follow these steps to install the Wunder RS scale with a fixed spreader bar.
-
Step 1: Attach the scale to the spreader bar. Ensure correct alignment. [Checkmark symbol] indicates correct installation, [Cross symbol] indicates incorrect installation.
Diagram shows attaching the scale unit to the spreader bar, with close-ups of connection points and required tool sizes (2.5 mm and 5 mm).
-
Step 2: Connect the scale's power and data cables.
Diagram shows connecting cables to the scale unit and the patient lift's control box.
-
Step 3: Secure the scale unit.
Diagram shows securing the scale unit with fasteners.
-
Step 4: Attach the spreader bar to the patient lift arm.
Diagram shows attaching the spreader bar to the lift arm, with arrows indicating the connection points.
-
Step 5: Ensure all connections are secure. [Warning symbol] indicates a point requiring attention.
Diagram shows a close-up of a connection point with a warning symbol, indicating the need for careful assembly.
-
Step 6: Final check of the scale and spreader bar assembly. [Warning symbol] indicates a point requiring attention.
Diagram shows the assembled scale and spreader bar attached to the patient lift, with a warning symbol on a connection point.
This instruction is an extract from the service manual. The service manual is available in other languages and can be downloaded from the Invacare website. For more information, contact the Invacare representative in your country.
