WOFI SAVANNAH Pendant Lamp

Introduction

Thank you for purchasing this WOFI SAVANNAH lamp. This product has been manufactured using the latest technology and complies with applicable European and national standards. To ensure safe operation and maintain its condition, please follow these operating instructions carefully.

Safety Instructions

• Connect the light only to a legally installed electrical power supply whose voltage matches the light's technical data.
• Disconnect the power supply before performing any work on the lamp, such as cleaning or replacing the light bulb.
• If the lamp or its cable shows signs of damage, disconnect it from the power supply immediately. It must only be reconnected and used again after repair by an authorized person.
• Keep children away from this electrical appliance.
• The lamp is intended only for use indoors in dry environments. It is not suitable for use in explosive atmospheres or for commercial situations.
• Never hang any object on or above the light, as this poses a risk of short-circuiting and fire.
• Do not use the light near liquids and avoid contact with water or splashes.
• Keep packaging material and plastic bags out of the reach of children due to the risk of suffocation.
• The area around the light bulb gets hot. Maintain a minimum distance of 0.3 meters from flammable objects.
• Replace defective light bulbs only with bulbs of the same type and power. When replacing bulbs, do not touch them with bare hands. If accidental contact occurs, clean the new bulb with a non-greasy cleaning product.
• Allow bulbs to cool down for a few minutes before handling to prevent burns.
• WOFI accepts no responsibility for damage to persons or objects caused by incorrect operation or failure to comply with these safety notices. Guarantees will be invalidated in such cases.

Intended Use

• The lamp is designed exclusively for use in dry indoor environments.
• It is not suitable for use in explosive atmospheres or for professional/commercial applications.

Items Supplied

• High-voltage pendant lamp
• Glass shades
• Energy-saving lamps (E14/5.5W)
• Operating instructions

Please check the contents for completeness and any damage.

Installation and Setup

Before setting up the light, please observe the following:

• Ensure all screw connections are tightly secured before use.
• If the lamp or its wires are not hanging straight after ceiling installation, the wires may need adjustment.
• To adjust the wires, press the push-button (A) located on the side of the connection unit. The wires can then be pulled out, pushed in, or rotated slightly. Release the button to fix the wires in their new position.
• The wires must not be pulled over sharp edges, tightly crimped, shortened, or lengthened.
• Do not hang decorative objects on the wires.
• If the wire insulation is damaged and the red inner insulation becomes visible, the light must be switched off immediately and dismantled by a qualified electrician.

Step-by-Step Installation

Step 1: Mount Ceiling Bracket

• Securely attach the ceiling mounting bracket (②) to the ceiling using appropriate screws (③, ④).

Step 2: Attach Lamp Body

• Connect the main lamp body (①) to the mounted bracket using the provided screws (⑤).

Step 3: Adjust Wire Length

• To adjust the height of the pendant(s), locate the adjustment button (A) on the connection unit.
• Press and hold button (A) to release the wire.
• Pull the wire out or push it in to set the desired length.
• Release button (A) to lock the wire in its new position.

Step 4: Install Bulbs and Shades

• Carefully screw in the energy-saving bulbs (⑧) into the sockets. Ensure they are correctly fitted.
• Attach the glass shades (⑥) and secure them with the retaining rings (⑦).

Step 5: Final Checks

• Ensure bulbs are properly seated.
• Verify all connections are secure.

Functioning

• To adjust the height, grasp only the counterweight or the wire (not the glass shade or metal fitting).
• Caution: HOT! The area around the bulb can become very hot.
• Avoid jerky movements when adjusting the wires.

Technical Data

• Voltage: max. 230 V ~
• Protection Class: I
• Type of Protection: IP20
• Included Bulbs: Energy saving lamps E14/5.5 W

Symbol Explanations

• [Distance Symbol]: Minimum distance to illuminated areas or flammable materials (in meters).

• [Flammable Surface Symbol]: Lamp suitable for direct mounting or use on normally flammable surfaces (e.g., wood ceilings).

• [Replace Cover Symbol]: Always replace a cracked protective cover.

Warranty

• WOFI provides a two-year warranty covering function, processing, and construction, starting from the date of purchase (receipt required).
• If a problem arises, please contact your retailer or the WOFI service department immediately.
• Warranty excludes damage from normal wear and tear, incorrect assembly, improper use, or unauthorized modifications.

Disposal

• Dispose of packaging materials separately according to local regulations.
• When disposing of the product, follow current regulations. Contact your local authority for details.
• [Recycling Symbol]

Manufacturer Information

WOFI LEUCHTEN

Wortmann & Filz GmbH & Co. KG
Im Langel 6
59872 Meschede

Website: www.wofi.de

Service Hotline

• Tel: 02903/449-449
• Fax: 02903/449-459
• Email: kundendienst@wofi.de