Instructions for EPSON models including: HC2200 Full HD 1080p Projector, HC2200, Full HD 1080p Projector, HD 1080p Projector, 1080p Projector, Projector
Procedure to update projector firmware with a USB cable from a computer 1. Save the firmware file to the computer a. Note: Do not change the file name of the firmware. If the file name changes, the firmware update will not work. 2. Disconnect the power cord from the projector and check that all the indicators on the projector are off. 3. Connect the computer to the projector with a USB-type B Mini cable. a. Connect the USB type-A connector to the computer. Connect the USB type-B connector to the Projector's USB-B port or USB mini-B port. 4. Connect the projector's power cord while holding down the projector's power button. a. All the projector's indicators will turn on (Update mode). b. When all the indicators turn on release the [ ] power button. 5. The computer will recognize the projector as a removable disk. a. From the computer, copy the .bin firmware file to the root of the Epson_PJ removable disk. b. Do not copy any other files or folders to the removable EPSON_PJ disk. c. Perform the steps to safely remove a USB device from the computer. If you are using a Mac OS X, perform 'Remove EPSON PJ". 6. Disconnect the USB cable from the projector and the computer. Once you disconnect the USB cable, after about 20 seconds all the projector's indicators will start flashing, and the firmware update will begin writing to the projector. i. Warning- Do not unplug the projector while the firmware is updating b. After the update finishes successfully, the projector will turn off and go into standby status. c. If the projector is not in standby status, the firmware update has not finished. Continue waiting, then check again. d. If the Direct Power On function is set to On. the protector turns back on again (only for models with the Direct Power On function enabled). Verifying the firmware version 1. Turn the projector on 2. Press the menu button and go to the Info tab a. If the version number displayed in the Info menu has changed, the firmware update has been completed normally. See your projector's on-line User's Guide for details on displaying the Info menu.Microsoft Word for Microsoft 365