User Manual for SUPER BRIGHT LEDS models including: LPDBL Series Dimmable LED Panel Light, LPDBL Series, Dimmable LED Panel Light, LED Panel Light, Panel Light, Light
Important: Read all instructions prior to installation. Dimmable LED Panel Light Dimensional Drawings LPDBL-xK24-50-S 23.75in 603.25mm User Manual LPDBL Series 47.75in 1212.85mm 1.61in 40.64mm Dimmable LED Panel Light LPDBL Series User Manual 2.46in 62.48mm 3/4 INCH CONDUIT KNOCKOUT 1.77in 44.96mm LPDBL-xK22-40-S 23.75in 603.25mm 2.12in 53.85mm 1.77in 44.96mm Rev Date: V1 07/01/2019 23.75in 603.25mm 1.50in 37.97mm LPDBL-40K24-50-S Rev Date: V1 07/01/2019 Important: Read all instructions prior to installation. Dimmable LED Panel Light User Manual LPDBL Series Included Parts 1 - LED panel Light Recommended Accessories · 010V Slide Dimmer (F019) · 010V Knob Dimmer (A019) Specifications Model Dimmable Operating Temperature IP Rating Product Weight LPDBL-xK22-40-S LPDBL-xK24-50-S 010 V -4°113° F(-20°45° C) IP20 4.45 lb (2 kg) 9.1 lb (4.1 kg) Check product label for specific electrical specifications related to installation. Improper installation will void warranty. Safety Information · Product should be installed by a certified electrician in accordance with applicable national, state, and local building and electrical codes. · To reduce the risk of electric shock, ensure that the main power source and circuit breakers are switched off before performing any installation or wiring procedures. · Avoid looking directly into the light when illuminated. · Failure to properly support the fixture may result in damage or injury, for which the manufacturer does not assume responsibility. A safety cable is not included, but it is recommended that one be connected to grid clip during installation. Wiring Diagram 100277 VAC Supply 010 V Dimmer Black White Green Purple Gray L L N N GND GND + + Black White Green Purple Gray/Pink Drop Ceiling Installation 1. Turn supply power to circuit off. If installing as a retrofit, remove existing fixture. 2. Open driver box and remove knockout(s) for wiring. Make electrical connections using wiring diagram. Once complete, resecure driver box cover. FIG 1 Firmly bend Safety Tabs up and out Safety Tab 3. Bend out safety tab to be vertical, then upper portion out 90 degrees. It is recommended that a safety cable (included) be installed to anchor the fixture as well. 4. Lay fixture into T-grid. FIG 2 Fixture Safet Tab T-Grid Driver Box Note: Tabs should secure light in T-grid while still allowing reinstallation of adjacent ceiling tiles. Rev Date: V1 07/01/2019Adobe PDF Library 16.0 Adobe InDesign 16.4 (Windows)