MomMed Wearable Breast Pump S21 (2 Pumps)

The User Manual in English

Parts list: 1

Assembling: 2-3

Control panel: 4-7

Instructions for pouring milk: 8

Storing your breast milk: 9

Frequently asked questions: 10-11

Product parameters: 11

After sales information: 12-13

Manual de instruction en español

¿Qué hay en el paquete?: 14

Armado del aparato: 15-16

Panel de control: 17-20

Instrucciones de extracción de leche: 21

Espacio del colector de leche: 22

Preguntas frecuentes: 23-24

Parametros del producto: 24

Información postventa: 25-26

Parts List

• (1) Wearable breast pump x2
• (2) 0.94 inch / 24 mm flange insert x2
• (3) Bra adjustment strap x2
• (4) Type-c cable x2
• (5) Small brush x2
• (6) Storage bag x2
• (7) User manual x1
• (8) Breastfeeding manual x1

Wearable Breast Pump Components

The wearable breast pump consists of the following parts:

• Silicone breast shields
• Pump motor
• Silicone diaphragm
• Milk collector + Linker
• Duckbill valve

Assembling

1. Place the silicone diaphragm into the milk collector and press firmly to ensure a tight seal.
2. Insert the silicone shield into the breast milk collector and press to ensure a tight seal. Ensure correct orientation.
3. Attach the pump motor to the milk collector, ensuring a perfect fit.
4. Connect the Type-C charging cable to charge the battery.

Note:

• The product has a built-in li-ion battery. Charge the pump motor with a certified 5V ⎓ 1A adapter when the battery indicator is red.
• A 5V ⎓ 1A power adapter is required and can be purchased separately if needed.
• Pumping duration should not exceed 20 minutes.
• Check all parts for malfunction or damage and replace as needed.

Cleaning and Sterilizing

1. Disassemble, wash, and sterilize all parts that come into contact with breast milk before first use and before each subsequent use.
2. After use, immediately disassemble and clean all parts that contacted the breast and breast milk (membrane, milk bottle, duckbill valve, shield) to prevent residue or bacterial growth. Use drinking water or detergent (water temperature not exceeding 100°C to avoid damage and deformation).

Control Panel

The control panel features:

• (1) Expression indicator
• (2) Stimulation indicator
• (3) Massage indicator
• (4) Level up button
• (5) Power button/Mode selection button
• (6) Level display
• (7) Battery display
• (8) Time display
• (9) Time/Minute
• (10) Level down button

Operation Cautions:

• Wipe components that do not contact breast milk with a soft cloth.
• Handle the valve and silicone diaphragm with care; damage will affect pump function.
• Clean the valve gently between fingers in warm, soapy water. Do not insert objects.

Display Description and Operation

1. Position the silicone funnel firmly against the breast, ensuring no gaps and nipple centering. Keep upright to maintain suction.
2. Press the power button lightly to start the breast pump; the timing display will illuminate.
3. Short press the power button (⏻) to switch to expression mode (☤). There are 12 levels. Adjust suction power using the '+' and '-' buttons for comfort.
4. Short press the power button (⏻) to switch to massage mode (♥). There are 12 levels. Adjust suction power using the '+' and '-' buttons for comfort.
5. Short press the power button (⏻) to switch to automatic mode (△). Levels 1-6 are massage mode (♥), and levels 7-12 are expression mode (☤). Automatic upshift occurs from levels 1-9 every 20 seconds. Levels 10-12 require manual adjustment. Adjust suction power for comfort using '+' and '-' buttons during upshifting.
6. Long press the power button (⏻) to turn off the breast pump.
7. After pumping, turn off the breast pump, lean forward slightly, and carefully remove it. If milk remains in the silicone shield, tilt the pump to pour it into a bottle.

Tips:

• The breast pump has a memory function, remembering the last used mode and suction level.
• The breast pump automatically stops after 20 minutes of operation.
• For optimal pumping, relax in a comfortable chair, lean forward slightly, and ensure the silicone shield is slightly inclined upward to facilitate milk flow and minimize residue.

Instructions for Duckbill Valve Installation

Insert the raised part of the duckbill valve into the round hole at the bottom of the suction bowl groove of the bra.

Instructions for Bra Adjusting Buckle

Adjust the length of bra straps for more comfortable pumping. Attach one end of the bra adjustment buckle to the inside buckle of the nursing bra and adjust the length as needed.

Instructions for Pouring Milk

After pumping, remove the breast pump, keep it upright, and remove the motor. Hold the milk collector to pour the breast milk into a bottle, aligning the collector gap with the bottle mouth to prevent spillage.

Storing Your Breast Milk

Breast milk storage

1. Store breast milk collected from sterilized breast pumps.
2. Place expressed milk in a clean, sterilized milk storage bag or a sealed milk bottle and refrigerate or freeze immediately.

Breast milk cold storage

1. Do not refreeze breast milk.
2. Do not mix fresh and frozen breast milk.
3. Discard any remaining breast milk after feeding.
4. Refrigerated milk is good for 48 hours; frozen milk is good for 3 months. Label with date and time. Avoid storing in the refrigerator or freezer door.

Thawing breast milk

Thaw frozen breast milk overnight in the refrigerator or by placing it in a bowl of warm water. Consumed within 24 hours of thawing.

Heating breast milk

1. Warm breast milk safely and quickly by placing the bottle in a bowl of warm water or a food heater.
2. Always check the temperature before feeding.
3. Do not use a microwave, as it can destroy nutrients and antibodies.
4. Avoid uneven heating, which can cause localized overheating and burns.
5. Do not heat in boiling water to prevent rupture or cracking.

Frequently Asked Questions (FAQ)

Q: Why does the breast pump leak milk?

Possible reasons and solutions:

• Incorrect milking position: Choose a comfortable seated position.
• Parts not disassembled during cleaning: Disassemble all parts for cleaning. Replace deformed parts.
• Duckbill valve and milk collector condition: Check for damage or wear. Replace if necessary to ensure proper milk flow.

Q: Why does the breast pump suck little breast milk?

The pump imitates a baby's sucking action. For increased milk production, try applying warm compresses for 3 minutes before use, then use massage or automatic mode for 3 minutes, and adjust settings for optimal frequency.

Q: Can a breast pump with a lithium battery be taken on a plane?

Yes, the built-in lithium battery capacity meets flight safety requirements.

Q: Why does the breast pump have a plastic smell?

A slight smell is normal due to BPA-free materials. Air out the product or wash with white vinegar or baking soda to eliminate odor.

Q: What should mothers pay attention to while breastfeeding?

1. Use a hot towel for 3 minutes before pumping to encourage milk production.
2. Adjust the pump to a comfortable level. Use massage or automatic mode for initial breast stimulation, then increase suction.
3. Pumping each breast for about 8 minutes is recommended. Do not exceed 20 minutes to avoid excessive suction.

Q: Why do I feel the suction of my breast pump is too low?

Ensure all parts are installed correctly and the breast pump is set to the appropriate gear.

Product Parameters

Warranty Card

Create with MomMed: MomMed Super User Club

Activate Your Warranty Now

(1) www.mommed.com Follow the Instruction

Click "Activate Now"

Thank you for shopping with us. We will solve any problems of the products you have purchased from our company. We don't stop caring about our products once they're yours. By activating your standard warranty, we're allowed to offer the best aftercare for your products and other possible issues.

24 support@mommed.com

Shenzhen TPH Technology Co., Ltd.
5th Floor, Building NO. 29 East Side, Lianchuang 2nd Technology Park, Bulan Road, Longgang District, Shenzhen, China.

UKREP APEX CE SPECIALISTS LIMITED
89 Princess Street, Manchester, UK M1 4HT
Tel:+441616371080
E-Mail:info@apex-ce.com

EC REP APEX CE SPECIALISTS LIMITED
Unit 3D North Point House
North Point Business, Park New Mallow Road co.cork,
T23 AT2P Ireland
Tel:+353212066339
E-Mail:info@apex-ce.com

CE ?

Warning

This is not a toy, keep out of reach of children.