Instruction Manual for valerie objects models including: V9018001 Ceiling Lamp, V9018001, Ceiling Lamp, Lamp

VO Instructionm ceiling lamp N°1

produktblad

Ceiling Lamp N°1 | | TAMBURSTORE.SE

instruction manual ceiling lamp n°1 - TAMBURSTORE

2022-11-02 — The luminaires may only be installed by authorized and qual ed technicians according valid regulations for electrical istallation.

VO Instructionm ceiling lamp N°1 - tamburstore.se

safety directions 4 Max 25W 1xE27 220-240V 50-60HZ 0,5m 1500 93 0 915 15 ø 250 protection class 1: the fitting must be earthed instruction manual ceiling lamp n°1


File Info : application/pdf, 2 Pages, 443.02KB

PDF preview unavailable. Download the PDF instead.

valerie-objects Instructionm ceiling lamp N°1
instruction manual ceiling lamp n°1
V9018001 M / Z
915 15
1500

930

ø 250

protection class 1: the fitting must be earthed

Max 25W 1x E27

the maximum wattage indicated in each lighting unit, for example, must not be exceeded

220-240V 50-60HZ
0,5m

for indoor use only, where direct contact with water is impossible
this luminaire was designed to work only with the indicated voltage
observe the indicated minimum distance between the lamp and the illuminated materials/objects

the armature can be used in combination with a dimmer. consult the sales outlet for the correct type
not to be disposed with domestic waste in rubbish bin, bring it to a staging area for electrical waste

safety directions
Please study the instruction manual carefully before installing or using this product. Keep this user manual for further reference / two persons needed for installation.
1. The luminaires may only be installed by authorized and qual ed technicians according valid regulations for electrical istallation. 2. Maintenance of the luminaires is limited to their surfaces. During maintenance no moisture can come into contact with any areas of
the terminal connections or voltage control parts. 3. Take account of the minimal separation distance from other objects and the room required around the fitting. 4. If in any doubt, consult a professional, taking local installation requirements into account. Some countries stipulate that lighting may
be installed only by registered installers. 5. When replacing a lamp, wait for it to cool, for a minimum of 5 minutes. 6. Clean with a clean, dry cloth or brush, use no solvents or abrasives. Avoid dampness on all electrical components. 7. Take account of all available technical information. 8. If the external exible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufaturer or his service
agent or a similar qual ed person in order to avoid a hazard.

1x ceiling lamp (frame + power cord
+ ceiling pot)

2x set wall brackets + spacers
(wall plugs included)

1x lamp shade

1x Led bulb silvered cap 4W - 350lm
2700 K (dimmable) energy class A+

1. assemble these two parts of the back part
2. 60 mm

2. drill two holes with the
requested diameter (ø 10 mm)
for the appropriate wall plugs according your type of ceiling

75 mm

ø 10 mm

560 mm distance in between

2.

5. take care: - do not screw the wall brackets tight - align careful the correct vertical hanging position - tight both brackets

3. screw back part of wall bracket into (by hand) the wall plug
4. screw carefully the frontpart of the wall bracket on the back part (by hand) make sure the spacers are in between

6. installation of the ceiling pot
1 4
3
2

1.

1.

2.

3.

2.

3.

1.
2. 3.
www.valerie-objects.com

1.

3.

2.



References

Adobe PDF library 15.00 Adobe Illustrator(R) 24.0