ambience | Lighting Design & Architectural Lighting Supply | Making Light Work
Installation Guide for ambience Lighting models including: Andro Trim, Adjustable Recessed Light, Andro Trim Adjustable Recessed Light, Recessed Light, Light
File Info : application/pdf, 2 Pages, 341.50KB
DocumentDocumentINSTALLATION GUIDE Everything you wanted to know but were too afraid to ask ANDRO TRIM think. again. IP20 WHOA, HOLD IT! 1 To avoid non-replaceable damage of custompainted fittings, the secondary ring must be removed before adjusting the inner tube. The inner tube must be adjusted at ground level before ceiling installation. 2 Hit the off switch on any power before install. 3 Install must only be carried out by someone suitably qualified. 4 Only use the product at the specified voltage and frequency. 5 It would be sweet if you the packaging. 6 Read Step 1 again. Thx. +61 3 9486 3699 sales@ambiencelighting.com.au ambiencelighting.com.au 1 Cut a hole in the ceiling as per the nominated cut-out sizes: S Ø98mm M Ø115mm L Ø128mm 2 Remove the secondary ring by rotating it anti-clockwise and pulling it out. 3 Push the housing in the hole. 4A Fix the screws onto the ceiling using a screw driver. 4B Tighten the screws until the flanges on the housing are retracted and the housing is held tight in its position. 5 Fix the secondary ring back onto the housing by rotating it clockwise and pushing it in. 6 Turn ON power supply to complete installation. 7 Now repurpose your andro packaging to plant some seedlings.