User Manual for MouKey models including: MWMU-5, MWMU5, 2AV7NMWMU-5, 2AV7NMWMU5, MwmU-5 UHF Wireless Microphone, MwmU-5, UHF Wireless Microphone
GUANGZHOU RANTION TECHNOLOGY CO., LTD. MWMU-5 2AV7NMWMU-5 2AV7NMWMU5 mwmu 5
Wireless microphone ! Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Content List 1Receiver 2Handheld Mic 3Power Adapter 4Audio Cable 5Manual AllRightReserved Wireless microphone MODEL: MwmU-5 Operating Manual A1 A2 Please read this manual carefully before use. A2 A1 7TECHNIQUE SPECIFICATION RECEIVER Carrier Frequency: 902-926MHz Dynamic Range: 96dB Distortion: 0.3% FrequencyResponse: 30-20KHz/+-2dB Signal / noise Ration: 96dB Receiving Sensitivity: -95dBm Transmission Delay: 3ms PowerSupply: DC12V500mA AudioOutput: 1x6.3mm, 2xXLRbalanceoutput HANDHELD MICROPHONE AND BODY-PACK MICROPHONE Carrier Frequency: 902-926MHz Power Output: 10-30mW Harmonic Radiation:- 50dBc Battery: 2x1.5VAAbattery Batterylife: 5h MANUAL CONTENTS Contents Brief Introduction Main Features Parts(Receiver) Receiver Display Receiver Operation Handheld Microphone Operation Body-pack transmitter(optional) Performance index MANUAL 8 8 MANUAL 1BRIEF INTRODUCTION Our company has designed and developed this excellent wireless microphone system, using a fully integrated solution, single-chip integrated microphone ampli er, DSP-based audio processor, phase-locked loop frequency synthesizer and so on. Compared with the traditional discrete device system, the stability and reliability of all the circuit modules are further improved. Our microphone uses the traditional FM modulation technology, has the superior RF performance and the audio performance, provides the professional grade sound quality experience for the user. 2MAIN FEATURES Optional UHF band(902-926MHz) All adopt the SMT process, circuit board design is compact. The receiver and transmitter use LED screen to show the frequency. Dedicated to large and small stages, dance halls, conference rooms, speeches family entertainment and so on. Multiple noise control circuit, refused to external disturbance and open the machine noise system. Excellent dynamic heart shaped cartridge for better clear sound. Effective open use distance of 70-90 meters. (4) Attention the using distance between the microphone Grille and mouth is less than 15 cm. (5) Avoid pointing the Grille against the Horn. 6BODY-PACK TRANSMITTER (OPTIONAL) MANUAL HANDHELD MICROPHONE USING TECHNIQUE (1) Don't hold the microphone Grille: MANUAL (2) Avoid holding the microphone on antenna position: antenna position (3) Don't put the two microphone to use together: 3PARTS(RECEIVER) MANUAL 9 10 WIRELESS MICROPHONE RECEIVER AF AF A1 A2 RF RF VOLUME-A VOLUME-B 1 234 5 67 8 1POWER 2VOL.A 3Channel A-AF indicator 4Channel A-RF indicator 5DISPLAY WINDOW 6Channel B-AF indicator 7Channel B-RF indicator 8VOL.B 9ANT-A 10ANT-B 11 12 11MIX.OUT 12BALANCE B DCINPUT 12V-18V 500mA 13 14 13BALANCE A 14DC INPUT MANUAL 4RECEIVER OPERATION Connect the power: Connect the power cable to the DC socket (10) or (1 4) of the Receiver, make sure the adaptor is suitable before using the Receiver. Connect the audio cable: Mix output: connect the audio cable (attached) to the MIX.OUT socket (8) (11) while the other side connect to MIX. IN or AUX IN. DCINPUT 12V 500mA Turn on the power button (1),Receiver is in working status. Note: Before turn on the Receiver, turn the volume control knob (2.8) to the minimum volume, adjust the volume as needed when the Receiver is working. Warnings of Receiver installation Beyond 1 meter more away from the wall Beyond 1 meter more away from the floor Antenna fully pull out, or will effect receiving signal fAulnl ytepnunllaout Beyond 1 meter more MANUAL Beyond 1 meter more 5HANDHELD MICROPHONE OPERATION 1 2 4 3 A1 1. Microphone capsule: use to pick up sound. 2. LCD display: indicates the microphone working status. 5 3. ON/OFF switch: control the handheld microphone of power on and off. 4. Battery Sink: insert 2x1.5VAA battery, note to insert in correct polarity. 5.Battery cover: battery for fixed the microphone.Corel PDF Engine Version 16.1.0.843