Installation Guide for Maxxsonics Usa models including: 211780005, 2AUK4-211780005, 2AUK4211780005, 211780005 Bluetooth Controller, Bluetooth Controller, Controller
MAXXSONICS USA, INC. 211780005 Bluetooth Controller 2AUK4-211780005 2AUK4211780005 211780005
6 mar 2024 — NOTE: This equipment has been tested and found to comply with the limits for a. Class B digital device, pursuant to Part 15 of the FCC Rules.3 pagine
Product Model21178-0005 PMN: Bluetooth Controller 1. Install the device 1.1 Location and Precautions: The Bluetooth audio controller can be installed in any suitable position in the car; Drill a 28mm hole and reserve a 64mm space behind the installation panel. Do not try to remove the control knob from the controller when installing; the knob and the controller are one unit. 1.2 When connecting the cable, ensure that the voltage output is 12V, and use the corresponding plug-in in the car to realize the connection 2. Usage (as shown in figure) : 2.1 Volume Control Slowly turn the knob clockwise to increase the volume and counterclockwise to decrease it; If the rotation is relatively fast, it will not increase the speed of the volume adjustment; 2.2 Switching Power Supply Press the knob inward for three seconds to turn the device on and off 2.3 Song Selection Swipe right or down to jump to the next song Jump to the previous song by swiping up or down FCC statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter. Radiation Exposure Statement The device has been evaluated to meet general RF exposure requirement. in portable exposure condition without restriction. ISED statement English:This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device. French: Cet appareil contient des émetteurs/récepteurs exempts de licence qui sont conformes aux RSS exemptés de licence d'Innovation, Sciences et Développement économique Canada. L'exploitation est soumise aux deux conditions suivantes : (1) Cet appareil ne doit pas provoquer d'interférences. (2) Cet appareil doit accepter toute interférence, y compris les interférences susceptibles de provoquer un fonctionnement indésirable de l'appareil. This device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS 102 RF exposure, users can obtain Canadian information on RF exposure and compliance. cet appareil est conforme à l'exemption des limites d'évaluation courante dans la section 2.5 du cnr - 102 et conformité avec rss 102 de l'exposition aux rf, les utilisateurs peuvent obtenir des données canadiennes sur l'exposition aux champs rf et la conformité. This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment. Cet équipement est conforme aux limites d'exposition aux rayonnements du Canada établies pour un environnement non contrôlé. The device has been evaluated to meet general RF exposure requirement. This equipment should be installed and operated with minimum distance 0mm between the radiator & your body. L'appareil a été évalué pour répondre aux exigences générales d'exposition aux RF. Cet équipement doit être installé et utilisé avec une distance minimale de 0 mm entre le radiateur et votre corps.Microsoft Word 2010