Installation Guide for HOOKE ROAD models including: BXG.8916-1S Tubular Doors, BXG.8916-1S, Tubular Doors, Doors
Hooke Road Bumper Installation Instructions | Installation Manual – Hooke Road 4x4
MAKE A DIFFERENCE Tubular Doors BXG.8916-1S (INSTALLATION INSTRUCTION) Please verify all parts are present and read instructions carefully before starting installation. Please feel free to contact your distributor if you have any kind of question about your purchase. 1 CONTENTS Front Doors Rear Doors Driver Side Passenger Side Qty Part Name 4 Button Bolt Size(mm) M8×45 16 Button Bolt 4 Button Bolt 16 Split Lock Washer 8 Split Lock Washer M8×20 M8×20 D8 D8 16 Flat Washer M8×20×1.5 Picture 2 TOOLS REQUIRED Qty Part Name 12 Flat Washer Size(mm) M8×20×1 16 Flange Lock Nut M8 4 Nylon Lock Nut M8 4 Nylon Round Spacer 27×13.5×14 4 Nylon Round Spacer 27×13.5×8 Picture To view online instruction, please scan the QR code. Drive Ratchet Handle 5mm Hex Bit Socket 13mm Wrench 3 INSTALLATION INSTRUCTION Step 1 Lower the door window completely and fold side mirrors fully forward until securely locked to ensure safe removal. Step 2 Fully open the door, find the wire connector, and pull it straight out while keeping the connector cover open. Step 3 Remove the upper and lower hinge bolts. Lift the door straight up to detach it from the vehicle. Repeat this step for the other doors. Distinguish the installation position of the hinge according to the figure below. Step 4 Step 5 (Driver Side Front Door) Secure the door hinges to the door. Do not fully tighten to allow adjustability. Repeat this step for the other doors. (4) M8×20 Buttom Bolts (4) M8×20×1.5 Flat Washers(Black) (4) D8 Split Lock Washers (4) M8 Flange Hex Lock Nuts Step 6 Secure the tubular door to the the vehicle by aligning and putting into the hinges. Close the door and adjust the door to the desired location. Tighten all bolts. Upper Position Lower Position (1) 27*13.5*14 nylon round spacer (1) 27*13.5*8 nylon round spacer (1) M8×45 Buttom Bolts (2) M8×20×1 Flat Washers (1) M8×20 Buttom Bolts (1) M8×20×1 Flat Washers (1) D8 Split Lock Washers (1) M8 Nylon Lock Nuts (1) D8 Split Lock Washers Upper Lower Step 7 If you hear abnormal noises from the door lock while driving, loosen the M6 screws and adjust the latch position. Repeat all steps on the other doors of the vehicle. Step 8 Step 9 The installation is complete. We hope you enjoy a wonderful off-road life with this quality Hooke Road product! to find your parts. Feel Free To Share Your Vehicle @HookeRoad4x4 With The Hashtag #hookeroad If You'd LikeAdobe PDF library 16.00 Adobe Illustrator 25.4 (Windows)