User Guide for PHILIPS models including: RC4873401, RC4873401 Remote Control, Remote Control, Control
HCS (Suzhou) Limited RC487A Remote control 2AGOFRC487A 2AGOFRC487A rc487a
User guide for Remote Control RC4873401/01RP 1. Know your Remote 2. Backlight Key Behavior When "123/ Backlight" key is pressed, hidden key mode is enabled. 3. How to pair your RCU with TV 1) Long press (3s) `SOURCES' BT Pairing Advertising. 2) BLE RC pairing name - APHRC 3) RC to stay in pairing mode for 60s. Press any key to cancel pairing mode (See Cancel Pairing) 4) RC to store pairing info upon successful pairing. White LED at mic hole stays on for 3s if pairing. successful. 5) RC will only pair to 1 TV. Pairing info will be erased if user enter pairing mode again. 4. Voice Function Follow 2024 Linux RC voice protocol supporting On Demand, HTT voice models. The White LED will be turned on for the full duration of audio sample transmission. Note: During voice, any key press will not stop the voice transmission. 5. LED Backlight Condition 6. Sleeping Mode When without any activity, the RC enters sleeping for power saving purpose. The sleeping mode behaves as below: i) All LEDs are off. ii) IR stopped, and no RF data transmitting or receiving, after IDLE timeout, disconnect with host. iii) Any key press will wake up the RC. FCC Compliance Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. FCC Caution Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. User guide for Remote Control RC4873201/01RP 1. Know your Remote 2. Backlight Key Behavior When "123/ Backlight" key is pressed, hidden key mode is enabled. 3. How to pair your RCU with TV 1) Long press (3s) `SOURCES' BT Pairing Advertising. 2) BLE RC pairing name - PHLRC 3) RC to stay in pairing mode for 60s. Press any key to cancel pairing mode (See Cancel Pairing) 4) RC to store pairing info upon successful pairing. White LED at mic hole stays on for 3s if pairing successful. 5) RC will only pair to 1 TV. Pairing info will be erased if user enter pairing mode again. 4. Voice Function Follow Google Voice over BLE spec 1.0 supporting On Demand, PTT & HTT voice models. The White LED will be turned on for the full duration of audio sample transmission. Note: During voice, any key press will not stop the voice transmission. 5. LED Backlight Condition 6. Sleeping Mode When without any activity, the RC enters sleeping for power saving purpose. The sleeping mode behaves as below: i) All LEDs are off. ii) IR stopped, and no RF data transmitting or receiving, after IDLE timeout, disconnect with host. iii) Any key press will wake up the RC. FCC Compliance Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. FCC Caution Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.Microsoft Word for Microsoft 365