ITC Warranty & Return Policy
Installation Guide for ITC models including: 69728SS Docking Light, 69728SS, 69728SS Light, Docking Light, Light
303 Corporte rove Dr. Hudsonville MI 9426 Phone: 16.396.1355 itc-us.com 1. Determine the installation location and drill a 1/2” hole for the wire.
Index of /files/resources/
File Info : application/pdf, 1 Pages, 239.73KB
DocumentDocumentDocking Light Part#: 69728SS PARTS/TOOLS NEEDED: INSTALLATION INSTRUCTIONS Docking Light M4 Hex Nuts (not provided) Butt Splice Connectors (Not Provided) Power Drill Application Specific Sealant (not provided) IMPORTANT SAFETY INSTRUCTIONS. READ CAREFULLY FOR YOUR PROTECTION AND SAVE ALL INSTRUCTIONS. · Disconnect power before installing, adding or changing any component. · To avoid a hazard to children, account for all parts and destroy all packing materials. · It is recommended that fuse protection be added to the positive(+) input. · Technical Specs: Voltage: 10 - 14V DC | Current: 0.12A | Wattage: 1.6W 1. Determine the installation location and drill a 1/2" hole for the wire. Drill two mounting holes at 1.4" on center. 2. Using the wiring diagrams below, wire the light to the incoming 12V DC power. Test the light. 1.4" Incoming 12V DC Power Docking Light Black (-) Black (-) Fuse 12V DC (+) Red (+) 3. Feed the wires back through the hole and push the light into the mounting holes. Use application specific sealant around the light to prevent any ingress of water. Tighten the nuts on back to hold it in place. 3030 Corporate Grove Dr. Hudsonville, MI 49426 Phone: 616.396.1355 itc-us.com For warranty information please visit www.itc-us.com/warranty-return-policy DOC #710-00193 · Rev A · 07/30/21 Page 1 of 1