Control Instructions

Resetting the Base

1. Hold the [down button] until the base reaches its lowest position.
2. Release the [down button].
3. Hold the [down button] again until the display states [display: RST].
4. Release the [down button].
5. Hold the [down button] again until the base lowers slightly, then raises back up.
6. Release the [down button]. The base is now ready to use.

[control panel: RST, 2, M]

Memory Control

1. Adjust the base to the desired height.
2. Press [M button] followed by the desired preset number.
3. The preset is now set for that height.

[control panel: 1, 2, 3, 4, M]

Setting Upper Limit

1. Adjust the base to the desired maximum height.
2. Hold down the [M button] until the display states [display: S-] then release.
3. Press the [up button], then release. Hold the [M button] until the display flashes [display: 999] then changes to display the height.
4. The maximum height is now set.

[control panel: S-, 1, 2, 3, 4, M]

[control panel: 999, 1, 2, 3, 4, M]

[control panel: height display, 1, 2, 3, 4, M]

Setting Lower Limit

1. Adjust the base to the desired minimum height.
2. Hold down the [M button] until the display states [display: S-] then release.
3. Press the [down button], then release. Hold the [M button] until the display flashes [display: 000] then changes to display the height.
4. The minimum height is now set.

[control panel: S-, 1, 2, 3, 4, M]

[control panel: 000, 1, 2, 3, 4, M]

[control panel: height display, 1, 2, 3, 4, M]

Removing the Upper and Lower Limits

1. Hold down the [M button] until the display states [display: S-] then release.
2. Within five seconds, hold down the [M button] again for two seconds.
3. The display will flash [display: 555] then change to display height.
4. The upper and lower limits are now removed.

[control panel: S-, 1, 2, 3, 4, M]

[control panel: 555, 1, 2, 3, 4, M]

[control panel: height display, 1, 2, 3, 4, M]

Locking the Control

1. Hold down the [M button] until display switches from [display: S-] to [display: LOC].
2. The control is now locked.

[control panel: S- to LOC, 1, 2, 3, 4, M]

Unlocking the Control

1. Hold down the [M button] until display switches from [display: LOC] to the height display.
2. The control is now unlocked.

[control panel: LOC to height display]

[control panel: height display, 1, 2, 3, 4, M]