INSTRUCTIONS FOR USE

Preparation and Loading

Full of ball sockets made of glass

The magazine is filled with gel balls. The image shows a hand pressing down on the follower to load the balls.

Casings operation

The loaded magazine is inserted into the blaster. The image shows the magazine being slid into the receiver.

Accessory Installation

Installation of fire hats

Attach the flash hider to the barrel end.

Installation of silencers

Screw the silencer onto the barrel.

Installation of accessories

Various accessories, such as a rear-view mirror sight and a double mirror, are shown being attached to the blaster's rail system.

Operation and Power

Installation of batteries

Insert the rechargeable battery pack into the stock compartment of the blaster.

Support of swivel mounting

Attach a sling or strap to the swivel mounting points for carrying.

Electric mode

Switch the selector to 'Electric mode'. Pull the trigger to fire.

Manual mode

Switch the selector to 'Manual mode'. Pull the trigger to fire.

Battery Charging

Rechargeable batteries

Use the provided charger to recharge the battery. It is forbidden to use fast charge chargers. Attention: 1. Ensure the battery is fully charged before use. 2. Stop using the battery when the power is low. Charge it promptly to prevent damage from over-discharge.

Crystal Ball Preparation

CRYSTAL BALL IMMERSION PROCESS

Prepare crystal balls by soaking them in 180 ml of water for about 3 hours. The resulting crystal balls are approximately 7-8 mm in diameter.