Owner's Manual for LG models including: SLM3R 4.1 Channel Sound Bar, SLM3R, 4.1 Channel Sound Bar, Sound Bar, Bar
english
File Info : application/pdf, 4 Pages, 2.09MB
DocumentDocumentSIMPLE MANUAL Wireless Sound Bar Please read this manual carefully before operating your set and retain it for future reference. To view the instructions of advanced features, visit http://www.lg.com and then download Owner's Manual. Some of the content in this manual may differ from your unit. MODEL SLM3R ENGLISH FCC Compliance Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: y Reorient or relocate the receiving antenna. y Increase the separation between the equipment and the receiver. y Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. y Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. FCC RF Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with minimum distance 20 cm (7.8 inches) between the antenna and your body. Users must follow the specific operating instructions for satisfying RF exposure compliance. FCC Radio Frequency Interference Requirements: High power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to 5.85 GHz bands. These radar stations can cause interference with and/or damage this device. This device cannot be co-located with any other transmitter. Supplier's Declaration of Conformity Trade Name LG Responsible Party LG Electronics USA, Inc. Address 111 Sylvan Avenue, North Building Englewood Cliffs, New Jersey 07632 Email lg.environmental@lge.com MFL71485130 2007_Rev01 www.lg.com Copyright © 2021 LG Electronics Inc. All Rights Reserved. SL4R(SLM3R).DUSAWLH_SIM (Sheet)_MFL71485130.indd 4 LG Customer Information Center 1-800-243-0000 1-888-865-3026 USA, Consumer USA, Commercial Register your product Online! www.lg.com Printed in China 2021-06-07 1:19:57 Front Panel The buttons are located on the side. 1 (Standby) · · · · · · · · · ·Switches the unit ON or OFF. F (Function) · · · · · · · · · · · · · · · · · · · · · · · ·Selects function. p/o (Volume) · · · · · · · · · · · · · · · · · · · · Adjusts volume. Rear Panel DC IN · · · · · · · · · · · · · · · · · · · · · Connect to the AC adapter. OPTICAL IN · · · · · · · · · · · · Connect to an optical device. USB port · · · · · · · · · · · · · · · · · · · ·Connect to a USB device. Subwoofer Connection Place the wireless subwoofer near the sound bar and follow steps below. a Connect the power cord of the sound bar and the wireless subwoofer to the outlet. b Turn on the sound bar. · The sound bar and wireless subwoofer will be automatically connected. The subwoofer's yellow - green LED turns on. Manual Subwoofer Connection If the subwoofer does not make sound, try to connect manually. a Press PAIRING on the rear of the wireless subwoofer. · The yellow - green LED on the front of the wireless subwoofer blinks quickly. (If the yellow - green LED does not blink, press and hold the PAIRING.) b Turn on the sound bar. · Pairing is completed. The yellow - green LED on the front of the wireless subwoofer turns on. Keep the sound bar and the subwoofer away from the device (ex. wireless router, microwave oven, etc.) over 1 m (3.3 ft) to prevent wireless interference. 1 m ! (3.3 ft) TV Connection a Connect the sound bar to the TV using Optical cable. b Set up [External Speaker (Optical)] on your TV setting menu. TV Remote control Replacement of Battery Additional Device Connection a Connect to the external device like as follow. (Set-top Box, Player etc.) TV b Set the input source by pressing F repeatedly. C/V: Skip/Search N: Play/Pause - Bluetooth connection lock (BT LOCK): Select the Bluetooth function by pressing F repeatedly. Long press N and press it again to limit Bluetooth connection to only BT and LG TV. SOUND EFFECT: Selects a sound effect mode. - TV remote: Long press SOUND EFFECT and press it again to use TV remote control. FOLDER W/S: Searches a folder. J: Displays the information of a file, an input source or connected Bluetooth device name. - Auto Power ON/OFF: Long press J and press it again. : Adjusts sound level of each speaker. - Surround sound: Long press and press it again. REPEAT: Listens to your files repeatedly or randomly. Additional Information Specification Power consumption AC adapter Refer to the main label. · Model : DA-38A25 · Manufacturer : Asian Power Devices Inc. · Input : 100 - 240 V ~ 50 - 60 Hz · Output : 25 V 0 1.52 A · Model : MS-Z1520R250- 038A0-P · Manufacturer : MOSO POWER SUPPLY TECHNOLOGY CO., LTD. · Input : 100 - 240 V ~ 50/60 Hz · Output : 25 V 0 1.52 A Approx. Dimensions (W x H x D) 890.0 mm X 57.0 mm X 85.0 mm With foot (35 inch x 2.2 inch x 3.3 inch) Bus Power Supply (USB) 5 V 0 500 mA Amplifier (Total RMS Output 420 W RMS power) Design and specifications are subject to change without notice. Rear Surround sound Wireless Rear Speakers Kit included for real surround sound. (SPJ4-S) The wireless subwoofer (or wireless rear speakers kit) uses the 5.8 GHz band (upper channels 149 to 165). So it is recommended to change the wireless router channel to 5.2 GHz band (lower channels 32 to 48) to avoid interference with the wireless router. * Refer to the wireless router manual for how to change the wireless router channel. SL4R(SLM3R).DUSAWLH_SIM (Sheet)_MFL71485130.indd 5-8 2021-06-07 1:20:00 ENGLISH LG Customer Information Center 1-800-243-0000 1-888-865-3026 USA, Consumer USA, Commercial Register your product Online! www.lg.com SIMPLE MANUAL Wireless Rear Speakers Kit Please read this manual carefully before operating your set and retain it for future reference. To view the instructions of advanced features, visit http://www.lg.com and then download Owner's Manual. Some of the content in this manual may differ from your unit. MODEL SPJ4-S SPJ4-S(SL4R).DUSAWLW_SIM (Sheet)_MFL71485161.indd 1-2 Printed in China MFL71485161 2007_Rev01 www.lg.com Copyright © 2020 LG Electronics Inc. All Rights Reserved. 2020-07-15 11:17:16 FCC Compliance Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: y Reorient or relocate the receiving antenna. y Increase the separation between the equipment and the receiver. y Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. y Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. FCC RF Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with minimum distance 20 cm (7.8 inches) between the antenna and your body. Users must follow the specific operating instructions for satisfying RF exposure compliance. FCC Radio Frequency Interference Requirements: High power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to 5.85 GHz bands. These radar stations can cause interference with and/or damage this device. This device cannot be co-located with any other transmitter. Supplier's Declaration of Conformity Trade Name LG Responsible Party LG Electronics USA, Inc. Address 111 Sylvan Avenue, North Building Englewood Cliffs, New Jersey 07632 Email lg.environmental@lge.com Surround Sound On/Off When you turn on surround function, you can enjoy magnificent surround sound for all the input sound source with rear speakers. The initial setting for the surround function is OFF, turn the surround function ON to use it. Surround On: Press and hold button on the remote control about 3 seconds and then press button repeateadly to select ON - SURROUND in the display window. Surround Off: Press and hold button on the remote control about 3 seconds and then press button repeateadly to select OFF - SURROUND in the display window. Additional Information Specification of Wireless receiver Power requirement Refer to the main label on the wireless receiver. Power consumption Refer to the main label on the wireless receiver. Dimensions (W x H x D) Approx. 60 mm x 220 mm x 175 mm (2.4 inch x 8.7 inch x 6.9 inch) Design and specifications are subject to change without notice. About Ferrite Core (Optional) twice 1 Rear Speakers Connection Speaker design and connection method may be different according to models. Transparent Black stripe Rear speaker (Left) Wireless Receiver Rear speaker (Right) Black stripe Transparent a Connect the speaker cables to rear speakers correctly. b Connect the Wireless Receiver and the rear speakers (Grey: right, Blue: left) with the speaker cables. c Turn on the Surround function to enjoy surround sound. 2 Wireless Receiver Connection a Connect the power cord of the wireless receiver to the outlet. b Turn on the unit: The unit and wireless receiver will be automatically connected. The receiver's yellow - green LED turns on Wireless Receiver Connection Manually If the rear speakers do not make sound, try to connect manually. a Press PAIRING button on the rear of the wireless receiver. y The yellow - green LED on the wireless receiver blinks quickly. b Turn on the main unit. c Pairing is completed. y The yellow - green LED on the wireless receiver turns on. Set the distance between the sound bar and the wireless receiver as close as possible and keep them away from the device (ex. wireless router, microwave oven, etc.) over 1 m (3.3 ft) to prevent wireless interference. > 1 m (3.3 ft) The wireless subwoofer (or wireless rear speakers kit) uses the 5.8 GHz band (upper channels 149 to 165). So it is recommended to change the wireless router channel to 5.2 GHz band (lower channels 32 to 48) to avoid interference with the wireless router. * Refer to the wireless router manual for how to change the wireless router channel. SPJ4-S(SL4R).DUSAWLW_SIM (Sheet)_MFL71485161.indd 3-4 2020-07-15 11:17:19