RealPower PB-20k SE 20,000 mAh Powerbank
User Manual
Introduction
Thank you for choosing RealPower! Quickly and easily recharge your mobile devices anytime, anywhere with the RealPower PB-20k SE Powerbank. The status of the charging process can be read from an LED display.
Charging the Powerbank
To charge the power bank, connect the supplied charging cable to the power bank's IN/OUT port and via an AC adapter to a wall socket. The power bank will automatically charge itself completely. The integrated over-charge protection stops charging as soon as the battery is fully charged. The adapters and cables used for charging the power bank must comply with LPS and EN 60950-1:2006/A2:2013. The charging current should be at least 5V / 2,100 mA.
LED Status Indicator
A short press on the power on/off switch will indicate the remaining power bank charge via the LEDs:
- 1 LED lit = 0%-25%
- 2 LEDs lit = 26%-50%
- 3 LEDs light up = 51%-75%
- 4 LEDs light up = 76%-100%
[Illustration of LED indicators on the power bank, used to display the remaining charge level.]
Charging Devices
To charge your smartphone or other mobile device, connect the charging cable of your device to one of the charging ports (OUT or IN/OUT). Please note that the USB Type-C port can be used for both charging the power bank (input) and charging devices (output).
[Diagram showing the ports on the RealPower PB-20k SE power bank: two USB-A output ports and one USB Type-C port which supports both input (charging the power bank) and output (charging devices).]
Technical Specifications
Feature | Specification |
---|---|
Capacity | 20,000 mAh (74 Wh) |
Battery Type | 20,000 mAh Lithium Polymer Battery |
Input (USB Type-C) | DC 5 V / 2,000 mA max. |
Output (USB 2x) | DC 5V / 2,100 mA max. |
Output (USB Type-C) | DC 5V / 2,100 mA max. |
Total Output | 2,100 mA |
Safety Instructions
- This Powerbank has been equipped with a lithium-polymer battery, which attains its full capacity only after several complete charging and discharging cycles.
- Do not perform simultaneous charging and discharging of the Powerbank.
- Only use suitable power packs (observe the indications about voltage and charging current).
- Protect the Powerbank against collapse/fall; do not use it after a fall.
- Rechargeable batteries have a limited number of charging cycles and need to be replaced or disposed of after some time.
- Do not open the housing. In case of defects, please contact support or a specialist dealer.
- Charge the Powerbank every 3 months if it is not used, to maintain its full capability.
- Do not use the device in extremely cold, hot, humid, or dusty environments. Do not expose the Powerbank to direct sunlight.
- Protect the product against open fire; there is a risk of explosion!
- Do not bridge any contacts; risk of short circuit!
- Do not touch leaking batteries; risk of injury through burns!
- Risk of explosion if the battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.
- Do not dismantle, open, or shred the battery.
- Do not expose the battery to heat or fire.
- Avoid storage in direct sunlight.
- Do not short-circuit the battery.
- Keep the battery out of the reach of children.
- Keep the battery clean and dry.
- Do not leave a battery on prolonged charge when not in use.
- Do not subject the battery to mechanical shock.