User Manual for SHENZHEN models including: R1, R2, R3, R Series Remote Control Ring, R Series, Remote Control Ring, Control Ring, Ring
SHENZHEN LINGCHENG TRADING CO. LTD R1 Ring remote control 2BHBZ-R1 2BHBZR1 r1
User Manual PMN: Ring remote control Modle/HVINR1, R2, R3 After-sales emailTKservice001@outlook.com Packing list Charging case*1 Bluetooth ring*1 Type-C Cable*1 User Manual*1 Buttons function introduction NO. 1 2 3 4 5 6 7 Buttons Function Operation Power on Take out the automatic start-up Power off Auto Power Off Up/Flip up Return to auto shut down Power on and unconnected state, automatically power off after 3 mins Single click Down/Flip down Single click Left/Flip left Right/Flip right Single click Single click Confirmation Single click Notes Power off state Power on state Not connected state 8 Single like Double click 9 Continuous likes Long press 3S 10 Exit continuous likes Long press 3S In the continuous likes state 11 Take photos Single Click 12 Photo focus Long press 3S In the photo state 13 Photo focus Single click In the photo state 14 Volume + Single Click Not in the camera state 15 Volume - Double click Not in the camera state Press 2 buttons at the 16 Disconnect currently pairing same timered and blue lights flash Disconnect currently connected device alternately 17 Horizontal screen switch Long press 3S Only supports horizontal orientation on one side Light status introduction Charging case NO. 1 2 3 4 Lighting status Red light is always on Light off Red light flashes Blue light always on Ring NO. 1 2 3 4 Lighting status Red and blue lights flashing Red light flashes Red light is always on Blue light flashes once Function Put the ring on the charging cable, the charging case is charging Fully charged Low battery Ring charging,Fully charged blue light off Function Pairing status Low battery Charging in the charging case Remote control operation once Guides for Set-up Step 1iOS devices must first turn on AssistiveTouch cThe iOS system version is higher than 14.8 Settings>Accessibility>Touch>Turn on AssistiveTouch (Android phones do not have the dots Step 2The ring automatically turns on when taken out of the charging case Step 3Pair the Bluetooth "R1"cLights off Step 4Open the software and operate it Step 1 Step 2 R1 Step 3 Using on Camera/Video Single clickSwitch camera mode Single ClickTake photos Long press 3SPhoto focus Single clickSwitch camera mode Single clickPhoto focus Using on TikTokcOr other video playback software Single clickPrevious video Single clickNext video Single clickPause/Playback Double clickSingle like Long press 3SContinuous likes Long press 3SExit continuous likes How to switch the video to a horizontal screen? 1. Turn on the screen lock of the phone 2. Flip the phone to the left to landscape mode. Then long press 3S "Up" button to switch to horizontal screen operation mode 3. Single click "up" button: play the previous video Single click "down" button: play the next video Single click "OK" button: pause/play 4. Flip your phone to portrait mode. Then long press 3s "Up" button to exit the horizontal screen mode Using on E-book Two-Step Solution Scrolling Up/Down Too Far 1.Click to adjust text 2.Turn off continuous scrolling Single clickPage up Single clickPage down NoteOnly available for Kindle APP not for Kindle devices) Product parameters Model: R1 Frequency (Hz) : 20-20 khz Communication distance: 10 meters Charging case battery capacity: 250 Mah Ring remote control battery capacity: 40 Mah Charging time: about 1.5 hours Charging interface: Type-C ManufacturerShenzhen Zhijie Technology Co.,Ltd Address: B1010, Block B, Zhantao Technology Building,Xinniu Community, Minzhi Street, Longhua District,Shenzhen, China IC FCC ID FCC Warning: This device complies with Part 15 of the FCC Rules, Operation is subject to the following two conditions: (1)This device maynot cause harmful interference. (2)This device must accept any interference received, including interference that maycause undesired operation. FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. IC Warning - English: This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licenceexempt RSS(s). Operation is subject to the following two conditions: 1.This device may not cause interference. 2.This device must accept any interference, including interference that may cause undesired operation of the device. - French: Cet appareil contient des émetteurs/récepteurs exemptés de licence qui sont conformes aux RSS exemptés de licence d' innovation, sciences et développement économique Canada. Le fonctionnement est soumis aux deux conditions suivantes: 1. Cet appareil ne peut pas causer d'interférences. 2. Cet appareil doit accepter toute interférence, y compris les interférences qui peuvent causer un fonctionnement indésirable de l' appareil. Radiation Exposure Statement The device has been evaluated to meet general RF exposure requirement. The device can be usedin portable exposure condition without restriction. L'appareil a été évalué pour répondre aux exigencesgénérales d' exposition aux radiofréquences. L'appareil peut être utilisé en condition d' exposition portable sans restriction.Adobe PDF library 16.00 Adobe Illustrator(R) 24.0