Instructions for SIRHC LABS models including: CORTEX EBC Complete Kit with External, CORTEX EBC, Complete Kit with External, Kit with External, External

Kircher

2011-2014 GT

Cortex EBC Application Specific Instuctions - SIRHC LABS

[PDF] 2011-2014 Mustang GT 5.0L Specific Instructions - CORTEX EBC

SIRHC Labs 2022. VEHICLE CONFIGURATION SETTINGS. RPM DETECTION: • Mode: RPM. • Pulses Per Cycle: 7. • Rotations Per Cycle: 2. Page 3. SIRHC Labs 2022. GEAR ...

• Google Docs
• Google Drive
• Download [pdf]
• Download Optimized



File Info : application/pdf, 5 Pages, 481.80KB

Document Document

CORTEX EBC
2011-2014 Mustang GT 5.0L Specific Instructions
Rev 2.0.0
WIRING
The 2011-2014 Mustang GT PCM is in the passenger side of the engine bay next to the fuse box. The PCM has three connectors. Power, RPM, vehicle speed, and throttle position signals can be accessed at these connectors. When the PCM is installed in the car the Transmission connector will be at the top, the Engine connector will be in the middle, and the Cowl connector will be at the bottom.

The Cortex EBC wiring harness can be connected to the PCM connectors as outlined in the following table (C = Cowl Connector, E= Engine Connector, T = Transmission Connector). RPM and vehicle speed signals are required for boost by gear applications.

CORTEX SIGNAL +12V Power Ground Engine Speed Vehicle Speed
General-Purpose

CORTEX EBC TO PCM CONNECTIONS

CORTEX WIRE COLOR

PCM SIGNAL

Red

Switched PCM Power

Black (x2)

Connect to Chassis Near EBC

Pink

Intake Cam Position Sensor (CMP21)

Green

Output Shaft Speed

Orange

Throttle Position 1

PCM PIN C-67 N/A E-42 T-14 E-39

PCM WIRE COLOR Green / Blue N/A Yellow / Blue Brown / Green Brown

SIRHC Labs 2022

VEHICLE CONFIGURATION SETTINGS
RPM DETECTION: · Mode: RPM · Pulses Per Cycle: 7 · Rotations Per Cycle: 2
SIRHC Labs 2022

GEAR DETECTION: · Follow the steps in the Setup ­ Gear Detection section of the Help utility to determine the correct EVS ratio settings for gear detection.
SIRHC Labs 2022

SPEED DETECTION: · Follow the steps in the Setup ­ Vehicle Speed Detection section of the Help utility to determine the correct Pulses Per Mile setting. · NOTE: Gear detection setup should be performed before calibrating the Pulses Per Mile setting.
SIRHC Labs 2022

THROTTLE POSITION DETECTION: · Follow the steps in the Setup ­ Throttle Position Detection section of the Help utility to determine the correct Closed TPS Voltage and Open TPS Voltage settings.
SIRHC Labs 2022