OFFROAM Mounting Base Installation Instructions
Ford Bronco 2021-2025
Components
The following components are included:
- Mounting Base
- L-key (L-shaped tool)
[Illustration of the OFFROAM Mounting Base and the L-shaped tool]
Installation Steps
Step 01: Loosen Screws
Using the L-shaped tool provided, loosen the screws to open up the mounting base. Do not fully remove screws; keep about one thread engaged.
[Illustration showing the L-key being used to loosen screws on the mounting base, with a note indicating not to remove them completely]
Step 02: Hook Plates into Gaps
Hook the bottom mounting base plate into the BOTTOM GAP & hook the top plate into the TOP GAP as shown.
[Diagram showing how to hook the bottom and top plates of the mounting base into the vehicle's dashboard gaps, labeled 'BOTTOM GAP' and 'TOP GAP']
Step 03: Tighten Screws
Hold the mounting base in place and, using the L-shaped tool, alternately tighten both screws until hand tight.
[Illustration showing the L-key alternately tightening the screws on the mounting base]
Fitment Information
Fitment Note: Mounting base fits in the area where the bottom gap exists.
[Diagram illustrating the correct placement area for the mounting base within the vehicle's dashboard]
Watch This Install
For a visual guide, please scan the QR code below or visit our website.
[QR code for the installation video]
Scan the QR code to watch the installation video.
Visit us online at: offroam.com
Warnings
- Do not mount accessories in front of or near the path of airbag deployment.
- Check vehicle compatibility before installation to avoid damage to air vent bezel.
- Designed to work with OEM air vents. Not compatible with aftermarket air vent modifications.
- Do not mount heavy devices and/or use with long extension arms. Check the rated weight limit.
- Mount electronics away from air flow to prevent heat damage.
Disclaimer
Self-installation instructions and advice are provided for your convenience. It is your responsibility to determine if you have the knowledge, skills, and physical ability required to properly perform an installation. OFFROAM shall have no liability for damage or injury resulting from the installation or use of any OFFROAM or third party products. It is your responsibility to ensure that all products are installed in adherence with local laws and regulations and in such a manner as to allow a vehicle to be operated safely and without distraction. OFFROAM product warranties do not cover the installation, removal or re-installation of any product.
