MEAN WELL Switching Power Supply Manufacturer
Owner's Manual for MEAN WELL models including: PSP-600 series 600W with PFC and Parallel Function, PSP-600 series, 600W with PFC and Parallel Function, PFC and Parallel Function, Parallel Function, Function
PSP-600-24 MEAN WELL - РКС Компоненти - РАДІОМАГ
File Info : application/pdf, 3 Pages, 205.97KB
DocumentDocument600W with PFC and Parallel Function PSP-600 series User's Manual SPECIFICATION CNS14336-1 UL62368-1 Bauar t gepruft Sicherheit egelma ge od o s be wac g www. tuv.com ID 2000000000 BS EN/EN62368-1 GB4943.1 TPTC004 IEC62368-1 MODEL PSP-600-5 PSP-600-12 PSP-600-13.5 PSP-600-15 PSP-600-24 PSP-600-27 PSP-600-48 DC VOLTAGE 5V 12V 13.5V 15V 24V 27V 48V RATED CURRENT 80A 50A 44.5A 40A 25A 22.2A 12.5A OUTPUT CURRENT RANGE 0 ~ 80A 0 ~ 50A RATED POWER 400W 600W RIPPLE & NOISE (max.) Note.2 180mVp-p 240mVp-p VOLTAGE ADJ. RANGE 4.75 ~ 5.5V VOLTAGE TOLERANCE Note.3 ±2.0% 10 ~ 13.2V ±1.0% LINE REGULATION ±0.5% ±0.5% LOAD REGULATION ±1.0% ±0.5% SETUP, RISE TIME 1500ms, 50ms at full load HOLD UP TIME (Typ.) 20ms at full load 0 ~ 44.5A 600.75W 240mVp-p 12 ~ 15V ±1.0% ±0.5% ±0.5% 0 ~ 40A 600W 240mVp-p 13.5 ~ 18V ±1.0% ±0.5% ±0.5% 0 ~ 25A 600W 240mVp-p 20 ~ 26.4V ±1.0% ±0.5% ±0.5% 0 ~ 22.2A 599.4W 240mVp-p 24 ~ 30V ±1.0% ±0.5% ±0.5% 0 ~ 12.5A 600W 300mVp-p 41 ~ 56V ±1.0% ±0.5% ±0.5% VOLTAGE RANGE Note.5 88 ~ 264VAC 124 ~ 370VDC FREQUENCY RANGE 47 ~ 63Hz POWER FACTOR (Typ.) 0.95/230VAC 0.99/115VAC at full load INPUT EFFICIENCY(Typ.) 79% 84% 85% 85% 86% 86% 87% AC CURRENT (Typ.) INRUSH CURRENT (Typ.) 6.8A/115VAC 20A/115VAC 3.4A/230VAC 40A/230VAC LEAKAGE CURRENT <1.3mA/240VAC OVERLOAD 105 ~ 135% rated output power Protection type : Constant current limiting, recovers automatically after fault condition is removed PROTECTION OVER VOLTAGE OVER TEMPERATURE 5.75 ~ 6.75V 13.8 ~ 16.2V 15.5 ~ 18.2V 18 ~ 21V Protection type : Shut down o/p voltage, re-power on to recover Shut down o/p voltage, re-power on to recover 27.6 ~ 32.4V 31 ~ 36.5V 57.6 ~ 67.2V FUNCTION REMOTE CONTROL POK SIGNAL WORKING TEMP. RC+/RC-: Short = power on ; Open = power off PSU turn on: 3.3V ~ 5.6V PSU turn off: 0V ~ 1V -20 ~ +60 (Refer to "Derating Curve") WORKING HUMIDITY 20 ~ 90% RH non-condensing ENVIRONMENT STORAGE TEMP., HUMIDITY -40 ~ +85, 10 ~ 95% RH non-condensing TEMP. COEFFICIENT ±0.03%/ (0 ~ 50) VIBRATION 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes SAFETY STANDARDS UL62368-1, TUV BS EN/EN62368-1, CCC GB4943.1, BSMI CNS14336-1, AS/NZS62368.1, EAC TP TC 004 approved SAFETY & WITHSTAND VOLTAGE EMC ISOLATION RESISTANCE (Note 4) EMC EMISSION I/P-O/P:3KVAC I/P-FG:2KVAC O/P-FG:0.5KVAC I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25/ 70% RH Compliance to BS EN/EN55032 (CISPR32) Class B, BS EN/EN61000-3-2,-3, GB9245, GB17625.1, BSMI CNS13438, EAC TP TC 020 EMC IMMUNITY Compliance to BS EN/EN61000-4-2,3,4,5,6,8,11, BS EN/EN55035, light industry level, EAC TP TC 020 MTBF 1132.9K hrs min. Telcordia SR-332 (Bellcore) ; 142.2K hrs min. MIL-HDBK-217F (25) OTHERS DIMENSION 170*120*93mm (L*W*H) NOTE PACKING 1.9Kg; 8pcs/15.5Kg/1.00CUFT http://www.meanwell.com) The operating altitude is 2000 meters for CCC, 3000 meters for UL,TUV. The ambient temperature derating of 5/1000m is needed for operating altitude greater than 2000m (6500ft). https://www.meanwell.com/serviceDisclaimer.aspx File Name:PSP-600-SPEC 2022-08-08 Downloaded from Arrow.com. 600W with PFC and Parallel Function PSP-600 series Mechanical Specification RS Connector(CN5) : JST B-XH or equivalent Pin No. Assignment Mating Housing Terminal 1 RS+ JST XHP JST SXH-001T 2 RS- or equivalent or equivalent Terminal Pin No. Assignment Pin No. Assignment 1 AC/L 2 AC/N 3 FG 4 P(Current Share) 5 POK 6 R.C.G 7 R.C. 8~11 DC OUTPUT +V 12~15 DC OUTPUT -V 120 8 11.5 1234567 Case No.910A Unit:mm 2-M3 L=4mm max. 2-M3 L=4mm max. 150 185 170 150 Air flow direction 58.3 100 Block Diagram I/P EMI FILTER FG Derating Curve 93 50 14 max. 2-M3 L=4mm max. 2-M3 L=4mm max. 12 CN5 8 9 10 11 12 13 14 15 9.5 11.5 ACTIVE INRUSH CURRENT LIMITING RECTIFIERS & P.F.C. POWER SWITCHING O.L.P. PWM CONTROL FAN SIGNAL CONTROL PFC fosc : 88KHz PWM fosc : 100KHz POK RECTIFIERS & FILTER O.C.P. DETECTION CIRCUIT CURRENT SHARING CIRCUIT P RS+ +V -V RC.G. RC RS- O.V.P. O.T.P. Output Derating VS Input Voltage LOAD (%) LOAD(%) 100 Others 80 60 12V 50 40 20 -20 0 10 20 30 40 45 50 60 (HORIZONTAL) AMBIENT TEMPERATURE () 100 90 80 70 60 50 40 88 100 115 135 155 INPUT VOLTAGE (V) 60Hz 230 264 File Name:PSP-600-SPEC 2022-08-08 Downloaded from Arrow.com. 600W with PFC and Parallel Function Control Terminal Instruction Manual POK(+) RCG(-) PSP-600 series RCG RC L N FG P POK RCG RC L N FG P POK RCG RC L N FG P POK RCG RC +V +V +V +V -V -V -V -V RS+ RS- +V +V +V +V -V -V -V -V RS+ RS- +V +V +V +V -V -V -V -V RS+ RS- + - LOAD + - LOAD POK Signal POK Signal is the voltage difference between "RCG" and "POK" pin output POK Signal for TTL level signal PSU turn on: 3.3V ~ 5.6V PSU turn off: 0V ~ 1V Remote Sensing + - LOAD Remote Control Power ON: RCG and RC for short Power OFF: RCG and RC for open Parallel Operation with Remote Sensing (1)Parallel operation is available by connecting the units shown as below (+S,-S and P are connected mutually in parallel) : (2)The voltage difference among each output should be minimized that less than 0.2V is required. (3)The total output current must not exceed the value determined by the following equation (Output current at parallel operation) =(The rated current per unit) x (Number of unit) x 0.9. (4) In parallel operation 4 units is the maximum, please consult the manufacture for other applications. (5) When remote sensing is used in parallel operation, the sensing wire must be connected only to the master unit. (6) When in parallel operation, the minimum output load should be greater than 3% of total output load. (Min. load > 3% rated current per unit x number of unit) LOAD +V -V +S -S + - P RCG RS+ RS- PSU + - P RCG RS+ RS- PSU + - P RCG RS+ RS- PSU + - P RCG RS+ RS- PSU Downloaded from Arrow.com. File Name:PSP-600-SPEC 2022-08-08