TETRIX Frame Round 74 Installation Guide

Installation Steps

Step 1: Wiring Connection

Prepare the luminaire for installation. Connect the electrical wires as shown. The diagram indicates a required cutout diameter of Ø68 mm, marked with ❌ [required cutout diameter].

The diagram shows electrical wires (red and black) being connected to the luminaire unit. A symbol ❌ [incorrect wiring warning] is present next to the connection point, suggesting caution with the wiring method.

An action is indicated with an arrow: [up arrow], suggesting insertion.

Note: The TETRIX LED-UNIT SHOULD BE ORDERED SEPARATELY.

Step 2: Unit Insertion and Driver Connection

Insert the luminaire unit into the prepared opening in the ceiling or mounting surface. Connect the modular LED driver to the unit. Text indicates [INSTALL UNINSTALL].

Step 3: Frame Attachment

Attach the frame to the luminaire unit to complete the installation.

Technical Specifications & Dimensions

The following dimensions are critical for installation:

Recess Size: 200 x 200 mm (marked with ❌ [required dimension])
Cutout Diameter: Ø68 mm (marked with ❌ [required dimension])
Unit Depth: 110 mm

Minimum clearances are required: 20 mm on one side and 1 mm on another side of the unit within the recess.

Safety Information

LIGHT SOURCE - DO NOT TOUCH LED

Touching the LED can result in permanent damage of the light source. The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person.

PREVENTING ELECTROSTATIC DAMAGE

⚠️ A discharge of static electricity may damage sensitive components. Always be properly grounded when touching leads or circuitry inside the luminaire. Use a wrist strap connected by a ground cord to the housing. Avoid touching the light sources with bare hands.

Drivers & Accessories

For the latest version of the driver matrix and available accessories, check www.supermodular.com or connect with your sales contact.

Compliance: CE marking indicates conformity with European standards.