Fanttik NB8 Nano Pressure Washer
User Manual
Read this manual carefully before use and keep it for future reference.
1. Safety Warnings
WARNING: Read all safety warnings and instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury.
Please read and comply with all original instructions before the initial operation of your appliance and storage the guidance for future reference or subsequent owners.
Apart from the notes included, the general safety provisions and rules for the prevention of accidents of the legislator must be observed.
Warnings and notes that are attached on the appliance provide important notes for the safe operation.
DANGER: All circuits in the working area must be protected from jet water.
The user must be the operator as intended. The person must consider the local conditions and must pay attention to other persons in the surroundings when operating the washer.
Before each operation, check important components such as high-pressure hoses, hand spray guns and safety devices for damage. Do not operate washer with damaged components.
High pressure nozzles can be dangerous if misused. The spray must not be directed at persons, live electrical equipment, or the machine itself.
ATTENTION: Do not operate the washer at temperatures below 0°C.
DANGER: Pressure washer must not be operated in explosive atmospheres. Explosion risk - Do not spray flammable liquids.
Never use acidic solvents containing solvents or undiluted! This includes gasoline, paint thinner, and heating oil. Spray can be highly flammable, explosive, and toxic. Do not use acetone, undiluted acidic solvents as they will corrode the materials used on the equipment. Never use the washer with flammable or toxic liquids, or liquids incompatible with normal operation.
Keep packaging films away from children, otherwise there is a risk of suffocation!
WARNING: In accordance with applicable regulations, cleaning machines must never be used on drinking water networks without a system separator. Ensure that the connection to the building water installation in which the cleaning machine is operated is equipped with a compliant system separator!
Water flowing through an anti-backflow valve is considered undrinkable.
To ensure applicable safety, only use original spare parts from the manufacturer or manufacturer approved.
WARNING: High-pressure hoses, fittings and couplings are important to machine safety. Use only hoses, fittings and couplings recommended by the manufacturer.
WARNING: Improper use of the cleaning machine may result in serious injury or oxidation.
Store the washer away from children.
Bleed any residual pressure before disconnecting the hose from the product.
Before each use, regularly check whether all metal fasteners are tight and whether the gasket components are intact; check whether parts are broken or worn.
Store indoors – Never store the washer outdoors or where it may freeze.
2. Package Contents
- NB8 Nano base x1
- Water tank x1
- Type-C cable x1
- Trigger gun (connected with hose) x1
- Spiral hose (connected with base) x1
- Use manual x1
The product includes a tank, sprayer, connector, tank cap, tray, charge inlet, frame, indicator panel, and ON/OFF switch.
3. How to Use
Operation:
- Place the device on a flat and leveled surface.
- Charge the battery (suggest using 5V/3A USB charger). Note: the charge indicator flashes during the charging procedure.
- Water supply from integrated water tank.
- Press the power switch I/O about 2 seconds, the appliance starts up. Note: Green light ON, Full Battery.
- Press the lever of the trigger gun.
- Release the switch of the trigger gun; the appliance will switch off again and stop the water jet. Note: Spray jet can lead to eye injuries and hearing damage. Do not direct the spray jet at eyes or ears.
- Press the power switch I/O about 2 seconds, the motor stops running.
- Pausing operation: Release the lever of the trigger gun.
- Finish operation: Turn off the power switch.
- Remove the tank.
- Switch the appliance on.
- Actuate the lever of the trigger gun until no more water is emitted.
- Completely empty the reservoir.
Charging Status:
| Charger status | Indicator light status |
|---|---|
| Normal charge | Green Scintillation |
| Battery filled | Green ON |
| Remove charger | OFF |
Battery Indicator:
| Indicator | Status |
|---|---|
| Red light ON | Low battery |
| Red light flashing | Empty Battery |
Attention:
- Only inject clean water into the water tank and ensure that only clean water is inhaled.
- Impurities in the water will damage the pressure pump and its accessories.
- Do not fill the water tank with any detergents, pesticides or other additives.
- Do not immerse the device in water.
- The pump is damaged due to poor operation of the equipment. If the device does not build pressure within 1 minute, switch off the device and follow the instructions in the "Troubleshooting" chapter.
- This low-pressure cleaning machine is designed for cleaning products, including vehicles, tools, exterior walls, garden equipment, and pets.
4. Specifications
| Feature | Specification |
|---|---|
| Motor Type | DC motor / 60W |
| Voltage | DC 12V |
| Rated Pressure (PSI) | 72-98PSI |
| Rated Flow (GPM) | 0.4-0.53GPM |
| Battery capacity | 2600mAh/12V |
| Input(charger) | 5V3A, 5V1A |
| Charging time (5V 1A Charger) | about 5H |
| Charging time (5V 3A Charger) | about 2.6H |
| Tank Volume | 8L |
| Hose Length | 3m |
| Gross Weights | 3.3kg |
| Storage Temperature | 0°-40° |
| Charging Temperature | 4°-40° |
| Product Size | 316*216*275mm |
5. Troubleshooting
| Symptom | Cause | Recommended action |
|---|---|---|
| The appliance refuses to start | Battery is empty Battery is protected Battery is too low |
Charging battery until green light. Turn On/Off switch to check if the unit starts. |
| Fluctuating pressure | Valves dirty, worn out or stuck Not reach required pressure |
Check that hoses and connections are airtight. Make sure that the valve opener is inserted with the pin pointing upwards. |
| The appliance pulsating | Air in inlet hose Inadequate supply of mains water Nozzle partially blocked Water filter blocked Hose kinked |
Allow machine to run with open trigger until regular working pressure resumes. Make sure there is enough water in the tank. Check that the water supply corresponds to specifications required. |
| The appliance starts, but no water comes out | No water supply Water filter blocked, Nozzle blocked |
Clean the filter. Clean the nozzle. |
| Charging slowly | Use 5V/1A charger | Check if you use 5V/3A charger & original USB cable. |
