Sharp Installation Instructions

STEP 1: Installing the Mounting Brackets

1a. Mark the center of the gable.

(Diagram description: A corner view of a cabinet structure, highlighting a vertical line marked as "MARK CENTER OF GABLE".)

1b. Align the Mounting Brackets with the mark, keeping it flush against the gable.

(Diagram description: Two mounting brackets are shown being aligned against a vertical surface (gable).)

1c. Secure each mount to the gables using two of the provided #6 wood screws.

(Diagram description: Close-up showing screws being inserted into the mounting brackets.)

STEP 2: Installing the Runners

2a. Insert the Alignment Tabs into the Runners as shown below.

(Diagram description: Illustrates inserting alignment tabs into the runners, with labels indicating "FRONT" and "REAR" for both left and right runners. A cut-out on the runner is shown to denote the front.)

2b. Place Runners on shelf and slide them so that the tabs stop against the gables.

(Diagram description: Shows runners placed on a shelf, with arrows indicating they should slide until the alignment tabs make contact with the gables.)

2c. Secure the Runners down with the provided #6 wood screws.

(Diagram description: Close-up showing screws securing the runners to the shelf.)

STEP 3: Installing the Microwave

3a. Place the Microwave on the Runners.

(Diagram description: Shows the microwave being positioned above the installed runners.)

3b. Lift and slide the microwave so that the front feet sit behind the lip of the front Alignment Tabs. This step ensures you have clearance to install the Frame mounting screws.

(Diagram description: Illustrates the microwave being slid back onto the runners, with its front feet designed to hook behind the lip of the front alignment tabs. An arrow indicates the sliding motion.)

STEP 4: Installing the Frame

4a. Peel the protective film off of the Frame.

4b. Place the Frame onto the cabinet face and secure onto the Mounting Brackets using the provided 8-32 screws.

(Diagram description: Shows the frame being placed onto the cabinet face, with mounting points indicated.)

STEP 5: Finalizing the Installation

5a. Open the Microwave Door and lift the Microwave up and towards you until the front legs clear the lip of the front Alignment Tabs.

5b. Push the Microwave back until the front legs make contact with the lip of the front Alignment Tabs. The Microwave face will now be flush with the Frame.

(Diagram description: Depicts the microwave being pushed back until its front surface is flush with the frame.)

5c. Adjust the Microwave horizontally as needed to center it in the Frame opening.

(Diagram description: Shows the microwave being adjusted left or right within the frame opening.)

5d. Your installation is complete - Stand back and admire a job well done.

Contact Information

Sharp Electronics of Canada Ltd.
5995 Avebury Road, Suite 900, Mississauga, ON L5R 3P9
Website: sharp.ca

For assistance or information about this kit, please call Sharp's Customer Assistance Centre at 905-568-7140.