mailto:info@originalgaragemoto.com
Installation Guide for ORIGINAL GARAGE models including: OG 2014-Up Touring Top Triple Tree, OG 2014-Up, Touring Top Triple Tree, Top Triple Tree, Triple Tree
Instructions Library
Install your new OG Top Triple Tree. Refer to the attached diagram for torque specifications and parts assembly. 7. The risers mounting blocks can be flipped ...
Arbre triple supérieur OG Drop 1" pour Touring 2014-2023
File Info : application/pdf, 2 Pages, 266.39KB
DocumentDocumentOG 2014-Up Touring Top Triple Tree Installation-1.0 Before beginning the installation, please note: If your bike still has the OEM Ignition switch/Fork lock, you will need to have your bike flashed with the "keyless CVO feature" at your local shop prior to starting the installation. Please refer to your bike service manual for additional guidance. 1. Disassemble: a. Road King: Remove the headlamp nacelle. Please be aware that installing on a Road King will require some trimming on the OEM headlamp nacelle. Additionally, you will need our OG Batwing Fairing Clamps for 2014-Up Touring Top Triple Tree to remount the headlamp nacelle. b. Street Glide: Remove the inner fairing assembly nacelle. Note that our OG Batwing Fairing Clamps for 2014-Up Touring Top Triple Tree are required for installation on a Street Glide. c. Road Glide: Remove the instrument nacelle. 2. Disconnect Wiring: a. Disconnect left and right handlebar switch connectors. b. For FLHXRS, disconnect the front turn signal lamp connectors. c. Disconnect the ignition switch connector. d. Disconnect the throttle sensor connector. e. Disconnect the upper fork bracket ground connector. f. If equipped, disconnect heated hand grip connectors. *For a smoother installation, keep your hand controls and switches installed on the handlebar. 3. Separate the handlebar from the top triple tree. 4. Remove the OEM top triple tree. 5. At this point, consider inspecting, cleaning, greasing, and tightening your neck bearing. 6. Install your new OG Top Triple Tree. Refer to the attached diagram for torque specifications and parts assembly. 7. The risers mounting blocks can be flipped for a 2" pullback setup. 1'' Pullback Mounting Blocks are available and sold separately. FL models with batwing fairing will need to run +2'' pullback risers position in order to clear the inner fairing. 8. Install Touring Risers bushing. We strongly recommend polyurethane bushings for risers lower than 9" and solid bushings for risers higher than 9". 9. Install your handlebar and risers on the top triple tree. 10. Reconnect the wiring. 11. Carefully route your wires using the supplied P-clamps. 12. Reassemble: a. Road King: Reattach the headlamp nacelle. b. Street Glide: Reassemble the inner fairing. Do not install the dash panel at this stage. Need help? info@originalgaragemoto.com OG 2014-Up Touring Top Triple Tree Installation-1.0 Page 1 of 2 OG 2014-Up Touring Top Triple Tree Installation-1.0 Need help? info@originalgaragemoto.com Page 2 of 2 OG 2014-Up Touring Top Triple Tree Installation-1.0