Please read all the information carefully before you use the product and keep the manual for future reference.
1. Specification
- Sensing module 90 degrees rotation
- 4 white LED light
- 3*AAA battery (not included)
2. Structure Description
- Sensing module 90 degrees rotation
- 4 white LED light
- 3*AAA battery (not included)
The light bar features a sensing module, LED lights, and a power source compartment. Components labeled include Power, Sensor, Light, and Photodiode. The battery compartment is covered by a Battery Cover. Installation is facilitated by a plastic buckle with 3M glue.
3. Installation Description
- Stick the plastic clips with 3M glue to the cupboard or closet. (Note: the lamp bar is placed on the right side of the entrance)
- Then push the lamp into the plastic buckle as the direction shown in the above picture.
4. Direction For Use
- Place the battery correctly and close the battery cover.
- Set the switch to "AUTO", the LED light goes into motion detect mode. When in a dark area, once a person or animal enters the sensing area, the light will turn on for 30 seconds.
- Set the switch to "ON" for Always on mode.
- Set the switch to "OFF" when not in use.
The device operates with three modes: 'AUTO' for motion detection (light stays on for 30 seconds in dark areas), 'ON' for continuous illumination, and 'OFF' for standby.
5. Detection Distance
The sensor has a detection range of approximately 3 meters and a field of view of 100 degrees.
6. Attentions
- This product should be used indoors; please do not use it in direct sunlight, rains, or heavy moisture.
- The sensor will not work beyond its sensing range.
- Battery life is a rough figure; it will be different depending on the frequency and time of use. Battery life from different brands will also be different.
- Please check for battery regularly. Remove the battery when not in use for a long period.
- Old and new batteries should not be used at the same time.
- Different types of batteries should not be mixed.
