User Manual for MICROTECH models including: 141078122, 141078122C, 141078222, 141078222C, 141078322, 141078322C, 141078122 Double Force Caliper, 141078122, Double Force Caliper, Force Caliper, Caliper
Double force carbide jaws caliper IP67 - MICROTECH - Innovative measuring instruments
MICROTECH WWW.MICROTECH.TOOLS DOUBLE FORCE EXT 8N INT 4N DOUBLE FORCE CALIPER MICROTECH USER MANUAL Calibration ISO 17025:2017 ISO 9001:2015 MICROTECH MODIFICATIONS Item No Range mm inch Resolution Accuracy* mm m Double force N Display Protection Carbide jaws 141078122 141078122C 0-150 0-6" 141078222 141078222C 0-200 0-8" 0,01 141078322 141078322C 0-300 0-12" ±10 ±10 8 ext Swiss Digit 4 int height 11mm IP-67 · · ±20 · *MAX ERROR FOR INTERNAL END DEPTH MEASUREMENTS DIN-862 BUTTON FUNCTIONS MODE SET DIGITAL BLOCK CHARACTERISTIC Item No Repeatability Max slider speed Display refresh rate Mean power consupt. Battery life IP specification Range mm 10 max 2,5 m/s >10/s 45A 8000 h IP67 (IEC60529) OPERATION INSTRUCTIONS MICROTECH Wipe with a clean cloth, soaked in gasoline, measuring surface of the frame and gauge calipers to remove anti-corrosion oil. Then wipe them with a clean dry cloth. This caliper has Autoswitch on/ off function: - move electronic module for switch on caliper - after 10 minutes without any moving caliper will switch off After finishing work wipe the measuring surfaces of the caliper with a cloth soaked in gasoline and apply anticorrosion oil BATTERY REPLACEMENT If necessary, open the battery cover; insert the battery (type CR2032) according to the polarity of the electrodes. Blinking display information or absence suggests replacing battery. DOUBLE FORCE CONTROL MEASURING EXTERNAL MEASURING with FORCE 8N ZERO SETTING FOR EXTERNAL - Contact external jaws to each other 8N - Push Force roll up to double-lines comes left on Force indicator and press SET button 2s. EXTERNAL MEASURING - When double-lines on Force indicator in left position - Measuring Force on External jaws 8±2N. 4N INTERNAL MEASURING with FORCE 4N PRESET INTERNAL VALUE - Contact internal jaws inside setting ring - PRESET setting ring size on caliper - Push Force roll up to right lines on Force indicator and press SET button 2s. INTERNAL MEASURING 4N - When double-lines on Force indicator in right position - Measuring Force on Internal jaws 4±1N. MICROTECH INSTRUMENT FIGURE Item No DIMENSIONS A B CD E G Display Protection mm mm mm mm mm mm IP 141078122 141078122C 141078192 235 40 10 16 Swiss 16 4x1,4 Digit height 11mm IP-67 141078192C 141078222 141078222C 141078292 290 50 141078292C 10 18 Swiss 16 4x1,4 Digit height 11mm IP-67 141078322 141078322C 395 60 141078392 141078392C 11 21 Swiss 16 4x1,4 Digit height 11mm IP-67 Change without prior notice Edition: M1017_0918Adobe PDF Library 16.0.5 Adobe InDesign 17.1 (Macintosh)