Blaupunkt Fiete 500 / Fiene 500 User Guide

Overview

The E-Bike is comprised of the following components:

• Handlebar
• Brake lever
• Stem
• Safe lock
• Stem folder
• Bike frame
• Front fork
• Disc brake rotor
• Chain wheel
• Bike frame folder
• Saddle
• Seat post
• Seat post clamp
• Motor
• Kickstand
• Rear Derailleur
• Pedal
• Chain wheel protection wheel

Package Contents

Your E-Bike package includes:

• E-Bike
• Saddle with seat post
• Charger
• User Manual
• Operating Instructions

Before First Use

It is recommended to wear appropriate protective gear such as a helmet and pads. The E-Bike is designed for use on paved roads and paths; any other use is not permitted.

Mounting the Handlebar

Note: It is advisable to have a second person help you hold the loose handlebar/tools. After unpacking the e-folding bike, fold up and lock the handlebar. Use the included tool (Allen key) to loosen the Allen screw under the handlebar cover (carefully remove the small cap on the screw beforehand). Carefully place the handlebar on the rod until the upper edge of the stem is max. 3-5mm above the top edge of the handlebar. If needed, loosen the two screws on the side of the stem. Tighten the two screws again, tightening them alternately until the handlebar can no longer be moved on the stem. Check handlebars for strength and correct position. Reassemble the cap.

Unfolding the Frame

1. Hold the E-Bike and unfold the frame.
2. Lock the folder clamp tightly. Before locking the clamp, please ensure steps 3 and 4 are completed.
3. If the fastener shows as pictured, press it down to release the convex piece.
4. If the fastener shows as pictured, you can then operate step 2 to lock the frame.

Unfolding the Stem

1. Hold the bike body and turn the stem upright to ensure that the stem is seamlessly connected to the underside.
2. Fasten the folding wrench directly in the direction of the stem.
3. Slightly shake the stem and check if the security buckle is fully buckled.
4. When folding the stem, press the security buckle and then open the folding wrench to it.

Saddle Assembly and Height Adjustment

4. Saddle Assembly

1. Open the seat post clamp, insert the seat post into the frame.
2. Close the lock (1), check the saddle for a firm seat. If necessary, adjust the lock with screw (2) when the lock is open.

5. Saddle Height Adjustment

1. To adjust the saddle height, first open the lock, set the saddle to the desired height, and then close the lock.
2. The saddle height must not exceed the Max./Min. markings.

Folding the Pedals

1. Hold the E-Bike and unfold the pedals.
2. Press the pedal towards the crank and fold it up.

Power On Operation

1. Before the first use, charge the battery completely. After removing the charger, close the charging port with the cover.
2. Press the M button for 3 seconds to boot.

E-Bike Computer

The E-Bike computer displays:

• Battery level (percentage and bar)
• Speed
• Support level
• Trip, ODO, TIME data

Button Functions:

• M: Multifunction button. Long press for 3 seconds to turn on/off the bike. Short press to switch between TRIP/ODO/TIME display.
• +: Short press to increase support level. Long press for 3 seconds to turn the front light on/off.
• -: Short press to decrease support level.

Support Levels:

• Level 0: No assistance, pure pedaling mode.
• Level 1: Low assistance, up to approx. 12 km/h.
• Level 2: Mid assistance, up to approx. 18 km/h.
• Level 3: High assistance, up to approx. 25 km/h.

Icons Meaning:

• [Headlight icon]: Front light is on.
• [Brake icon]: Brake is engaged.
• [ECN icon]: Indicates the throttle is not working or not working properly.
• [Motor icon]: Motor is not working or not working properly.
• [Controller icon]: Controller is not working or not working properly.
• TRIP ODO TIME: Switch among single trip mileage, total mileage, and running time.
• 88:88.8: Displays single trip mileage, total mileage, and running time.

Battery Removal/Installation

1. Turn off the computer, unlock the battery, lift the handle, and carefully pull out the battery box.
2. Insert the battery, lock it with the key, remove the key, and fold the handle.

Charging

Option 1: Charge the battery in the E-Bike. Open the rubber cap at the charging port and charge.

Option 2: Charge the battery outside the E-Bike. This saves you the trouble of moving the bike around.

Strolling and Carrying

Illustrations show the process of folding the e-bike for carrying.

Safety Recommendations

• Riding on motorways or other dangerous roads is prohibited.
• Riding on slippery roads is prohibited.
• Riding with one hand or no hands on the handlebar is prohibited.
• Riding on stairways is prohibited.

Technical Data

Mechanical Configuration

• Color options: White/Blue/Green
• Unfold size: 1520x570x1050mm
• Fold size: 810x650x600mm
• Seat height: 800-860 adjustment
• Wheel base: 1000mm
• Net weight (excl. battery): 19.6kg
• Brake system: Front and rear disc brake
• Tire Dimension (Inch): 20x2.125 inch
• Frame material: Integrated magnesium alloy frame
• Suspension system: N/A
• Max speed: 25km/h
• Max mileage: 45km
• Max load: 120kg
• Climbing angle: <15°
• Lighting: Front LED light
• Braking length (dry condition): 5m (speed at 20km/h)
• Braking length (wet condition): 10m (speed at 15km/h)
• Driven mode: EPAC
• Working temperature: -10°C-50°C

Battery

• Battery installment: Built-in/Lock/Removable
• Battery capacity: 36V/7.8Ah (18650 power battery)
• Battery type: LG Li-ion power battery
• Battery weight: 1.8kg
• Charging current: Max 2A
• Charging hour: 3–5 hours
• Power consumption per charge: 0.3KWH
• Battery lifespan: Over 800 times
• Charging temperature: 0°C-45°C

Charger

• Rated input: 100-240V 50/60Hz 2.0A
• Rated output: 42V 2A

Meter

• Display: Full perspective LCD display
• Remaining power: Yes
• Speed: Yes
• Total mileage: Yes
• Speed mode: 3 modes
• Voltage/Power: 36V/250W
• Rated Torque: 10.8Nm
• Waterproof level: IPX4

Remarks:

1. Mileage is subjected to weight, road condition, temperature, wind speed, riding habit, conditions, and the mileage on the UM is tested under the condition of loading 65kg, 25°C temperature, riding on flat road, wind less than 10Km/h with full electric.
2. Please use the original charger to charge the bike/battery.
3. Please do not modify the bike without authorization.

Quick Folding

Illustrations show the process of quick folding the e-bike.

Hazardous Material and Contents

○ means the ratio of the hazardous material in the parts is within the GB/T 26572 standard.

× means the ratio is beyond the GB/T 26572 standard in at least one part.

Matters Needing Attention

1. Please take the initiative to understand and comply with local traffic regulations before riding.
2. In case of accidents and injury, you should wear protective appliances well before riding, like helmet, gloves, elbow pads, knee pads etc.
3. You should check your bike conditions before riding (make sure that brakes work well, battery is fully charged, enough tire pressure, no abnormal sound, no screws loosen etc).
4. Do not ride on slippery road conditions, especially on snowy and watery roads.
5. Do not ride on slopes over 15°.
6. If you must ride when it's raining or snowing, keep it at a low speed and a longer distance from the vehicles in front of you, in case of emergency stops.
7. Kids under age 12 are not allowed to ride the e-bike.
8. Avoid sudden acceleration and deceleration, do not exaggerated lean, either forwards or back while riding, and keep it at a limited speed.
9. When the remaining battery power is low, please ride on low constant speed and charge the battery as soon as possible.
10. If a fall is inevitable, always keep your safety prior to the bike.
11. Do not put your hands in pocket while riding in case of emergency.
12. Do not store your bike in car trunk too long time in hot weather.
13. Please study the local traffic laws and regulations before riding, keep civilized riding.
14. Keep an eye on the surroundings, ride in a controllable condition and avoid any collisions that might occur.
15. Keep a safe distance from others while riding, and do not ride neck by neck on the road.
16. Do not ride in dim environments, if necessary, be cautious and lower your speed or stroll your bike.
17. Do not ride backwards and do not do any actions that might endanger yourself or others while riding.
18. Do not lend your bike to those who are not familiar with the manual.
19. Do not ride while you don't feel well, nor after taking drugs or consuming alcohol.
20. Do not lift your bike from tires, to avoid that your fingers get stuck between the tire and the casing.
21. Please speed up slowly. Sudden acceleration may cause out-of-balance and injure yourself.
22. Do check the brake function before riding, regularly adjust the brake wire tension.
23. The Power Assist Sensor (PAS) will start to work when pedaling 3/4~1 cycle. Beware of crank rotating when walk.
24. Brake lever control is left for front brake, right for rear brake.

Storage and Maintenance

1. Keep the e-bike in a place where there is no direct sunlight or no rain after riding.
2. Regularly check each screw of the e-bike and tighten it regularly. (Screw torque of each main position: head tube screw: 180-220 kgf.cm; saddle screw: 180-220 kgf.cm; front wheel nut: 250-300 kgf.cm; rear wheel nut: 300-350 kgf.cm)
3. If there is a stain on the surface of the e-bike body, wipe it with a soft cloth and a small amount of water. Do not use alcohol, gasoline, or other chemical solvents with corrosive and volatile properties, as this may seriously damage the appearance or internal structure of the e-bike body.
4. Chain elastic standard: chain up and down ≤ 10mm. If the chain is loose, loosen the rear wheel nut, adjust the chain tensioner to the chain fastening state, and tighten the rear wheel nut.
5. If the disc brakes and the disc plate friction, adjust the position to ensure no interference friction. If the disc plate is skewed or the disc brake is disabled, the disc or disc brake needs to be replaced.
6. Every 3 months, apply grease to the frame folding wrench screws and maintain the chain with chain anti-rust oil.
7. If the shock absorber fails or is damaged, replace the original shock absorber with a new one to achieve the best shock absorption effect.
8. Do not flush the e-bike with water to avoid accidents caused by internal electronic components and wiring.

Regular Maintenance & Check

Tip: Please maintain and check the e-bike regularly to keep it in the best riding condition.

Troubleshooting

No power assist after power on

• 1. Check to ensure the battery is mounted well.
• 2. Low voltage of battery, need to charge the battery.

Shortage of mileage

• 1. Check to ensure the charger function well.
• 2. Check the tire pressure before use.
• 3. Keep good riding habit.
• 4. Change battery.
• 5. Belongs to normal phenomenon.

Disable charge of battery

• 1. Check charger plug is loose or not.
• 2. Wait till the temperature recovers to charging temp.
• 3. Wait till the temperature recovers to charging temp.

No data display on meter

• 1. Check battery to ensure it is mounted well; battery low voltage, charge battery.
• 2., 3. Contact AFS department, change defective parts.

Motor cannot start when power on and turn the throttle

• 1. Check to ensure it's not on braking status.
• 2. Contact AFS department, check the display.

Warranty Policy

Coverage

Notes:

1. Disassembly without permission, external collision, man-made damages are not under warranty.
2. Consumables parts (brake pads, brake wires, tires and tubes, mudguards and other plastic parts) are not covered in the warranty.
3. Repairing of man-caused damages or beyond warranty time will be charged accordingly.

Warranty validity: from the date of shipping.

Contact Information

Competence Center Car Multimedia & Foldable E-Bikes

Evo-Sales GmbH

Hastenbecker Weg 33

31785 Hameln/Deutschland

www.blaupunkt.com