User Guide for RAKwireless models including: RAK3400, RAK3400 Bluetooth LoRa Module, Bluetooth LoRa Module, LoRa Module, Module
Shenzhen RAKwireless Technology Co.,Ltd. RAK3400 Bluetooth module 2AF6B-RAK3400 2AF6BRAK3400 rak3400
File Info : application/pdf, 12 Pages, 1.72MB
DocumentDocumentRAK RAKwireless Technology Co., Ltd. RAK4630 Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution: Changes or modifications not expressly approved by the part responsible for compliance could void the user's authority to operate the equipment. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. FCC RF Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and any part of your body. FCC Statement: "This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help." IC statement: This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisee aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioelectrique subi, meme si le brouillage est susceptible d'en compromettre le fonctionnement. This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and any part of your body. Pour se conformer aux exigences de conformité CNR 102 RF exposition, une distance de séparation d'au moins 20 cm doit être maintenue entre l'antenne de cet appareil ettoutes les personnes. This equipment complies with Industry Canada radiation exposure limits set forth for an uncontrolled environment. Cet equipement est conforme a l'exposition aux rayonnements Industry Canada limites etablies pour un environnement non controle. I www.RAKwi reIess.com I 11 Copyright© Shenzhen RAKwlreless Technology Co., Lid RAK RAKwireless Technology Co., Ltd. RAK4630 The proposed FCC IC label format is to be placed on the module. If it is not visible when the module is installed into the system, "Contains FCC ID: 2AF6B-RAK3400, Contains IC: 25908-RAK3400" shall be placed on the outside of final host system. Labelling - This radio transmitter [25908-RAK3400] has been approved by Innovation, Science and Economic Development Canada to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with this device. -- Le present emetteur radio [25908-RAK3400] a ete approuve par Innovation, Sciences et Developpement economique Canada pour fonctionner avec les types d'antenne enumeres cidessous et ayant un gain admissible maximal. Les types d'antenne non inclus dans cette liste, et dont le gain est superieur au gain maximal indique pour tout type figurant sur la liste, sont trictement interdits pour l'exploitation de l'emetteur. Antenna info Antenna type: IPEX Antenna MAMnaotdneeunflnanacatgmuareein:r::510S.16h-8e0dn1Bz3hi2e-nX1RAKwireless Technology Co., Ltd. Antenna type: PIFA Antenna Manufacturer: HL GLOBAL Model name: SA06LWEG01RA Antenna gain: 3.4dBi I www.RAKwi reIess.com I 12 Copyright© Shenzhen RAKwlreless Technology Co., Lid