Instruction Manual for ZIKUN models including: G633, G633 3 In 1 Wireless Charger, 3 In 1 Wireless Charger, Wireless Charger, Charger
SHENZHEN ZIKUN ELECTRONICS CO.,LTD G633 3 in 1 wireless charger 2BMNB-G633 2BMNBG633 g633
G633 :80x80 G633 3 in 1 Wireless charger Protective cases of airpods may cause unstable charging area Charging the Bluetooth headset: Please put the Bluetooth headset at the center of the charging area. 107*76*131.2(mm) 9V 2A,9V 3A G633 Type C 4. Matters needing attention: 4.1 When charging the device,do not use a protective cover with a thickness of more than 5mm, and do not use a protective cover with a metal sheet. 4.2 Do not put metal foreign objects in the charging area. 4.3 When charging, please aim the device at the center of the charging area. 5. Compatibility Sheet: 5.1 Smart phone iPhone 8/iPhone 8 Plus/iPhone X/iPhone XR/iPhone XS/iPhone XS Max/ iPhone 11/iPhone 11 Pro/iPhone 11 Pro Max/iPhone SE (2nd generation)/iPhone 12/ iPhone 12 Pro/iPhone 12 Pro Max/iPhone 13/iPhone 13 Pro/iPhone 13 Pro Max/ iPhone SE (3nd generation)/iPhone 14/iPhone 14 Plus/iPhone 14 Pro/iPhone 14 Pro Max/ iPhone 15/iPhone 15 Plus/iPhone 15 Pro/iPhone 15 Pro Max/iPhone 16/iPhone 16 Plus/ iPhone 16 Pro/iPhone 16 Pro Max and other phones that support wireless charging. 5.2 Smart Watch iWatch 3/4/5/6/SE/78/9/10/Ultra 1/Ultra 2. 5.3 Earbuds AirPods Pro 1AirPods Pro 2AirPods 4/3/2 Note: The charging box A1602/A2897 in AirPods 2 does not support wireless charging. Please check whether the earphone charging case supports wireless charging before use. FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. FCC RF exposure statement: The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance between 20cm the radiator your body.Pdftools SDK