Instruction Manual for FDPARTS models including: SC7X, SC7X 6 Way Master Switch MINI Controller, 6 Way Master Switch MINI Controller, Master Switch MINI Controller, Switch MINI Controller, MINI Controller
6 Way Master Switch MINI Controller P1 RED BLACK YELLOW BLUE Green GREY 1.Wiring Instructions 2.ENTER Programming Mode l l l 2.2:Master/Slave Setting(Gr 2.1:Latching/Momentary Setting
6 Way Master Switch MINI Controller 1.Wiring Instructions P1 P2 P3 P4 P5 P6 ON/OFF RED BLACK YELLOW BLUE Green GREY PURPLE White INPUT 10-30VDC+/MAX 40A INPUT GROUND P1 OUTPUT /MAX 10A P2 OUTPUT /MAX 10A P3 OUTPUT /MAX 5A P4 OUTPUT /MAX 5A P5 OUTPUT /MAX 5A P6 OUTPUT /MAX 5A 2.ENTER Programming Mode 2.1:Latching/Momentary Setting l To enter programming mode ensure that the controller is switched OFF. l PRESS and HOLD the ON/OFF master switch button,whilst depressed,push the corresponding Switch that you would like to program from ON/ OFF latching to Momentary activation which will be confirmed by an audible tone. l Repeat this procedure to program each of the 4 available switches. Beep 2.2:Master/Slave Setting(Group mode) l Power on the controller, press and hold the button to be set as the master, keep it until a BEEP sound. Then press the button to be set as the slave. l Cancellation: Power on, press and hold the master button, keep it until a BEEP sound, then press the slave button to cancel l Remarks: After set successfully of Master/Salve button, the salve button can still be controlled independently. NOTE: If the button is flashing the button is set as slave, if the button is constantly on the button is set as slave. If a button is programmed as momentary the button can t be used as slave, the button will be constantly on and if you press the master button (Momentary programmed) the button will not switch to flashing. Master Master 3.Mounting 3.1: 3M Sticker mount 3M VHB STICKER Beep Master Slave 3.2: Bracket mount 1/4 inch threaded holeCorel PDF Engine Version 17.3.0.772 CorelDRAW X7