Floor Lamps | Lamp Genius
Installation Guide for Lamp Genius models including: LISEV677958, 107609, 107610, LISEV677958 Freddo Floor Lamp, LISEV677958, Freddo Floor Lamp, Floor Lamp, Lamp
Freddo Floor Lamp, Polished Nickel, Clear Glass, 1 Light | Lamp Genius
File Info : application/pdf, 2 Pages, 653.21KB
DocumentDocumentInstallation and Safety Instructions LISEV677958 - Freddo Floor Lamp, Polished Nickel, Clear Glass, 1 Light TSroaubfeletsyhoWotiangrnings These instructions are for your safety. Please read through them thoroughly before use and retain them for future reference. If you are in any doubt about installing this product, consult a qualified electrician. This product is only suitable for connection to a 220-240V~ 50Hz supply. It is for indoor use only, and not suitable for a bathroom location. This fitting is a Class II, Double Insulated product and does not require an Earth. Live or Neutral must not be connected to Earth. Do not attempt to plug in or use this product until it has been fully assembled. Disconnect from mains during assembly or maintenance. this product must be used on a stable, flat surface. Under no circumstances must this floor lamp be covered with any material as this could pose a safety hazard. This product is not suitable for persons under 14 years of age. This product may contain delicate parts be careful during handling and maintenance to avoid breakage. The lamp must be protected by a 3 amp fuse in the mains plug. Never fit bulbs of a higher wattage than those specified on the label as these may damage the fitting. The lampshade part can be adjusted to an appropriate angle as needed.` Never put anything on the product or hang anything on any part of this product. If the external flexible cable or cord of this luminaire is damaged, it must only be replaced by a qualified electrician to avoid any electrical hazards. Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or local store for recycling advice. TCroaubrleesahonodtinmg aintenance For bulb replacement, unplug the product from the power source and allow it to cool down completely (Caution: bulb gets hot during use). Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product. TTroruobulesbhloeostihngooting When the bulb does not light after installation of the floor light: > Please plug in and operate the switch to turn your lamp on. > Please check the bulb. > Please check the 3 amp fuse in the plug and ultimately check the relevant fuse in your fuse box. If you have any doubt about installation/use of this product, consult a qualified electrician. UK Manufacturer: BH17 7BY EU Manufacturer: Brilliant AG, Brilliantstrasse 1, D-27442 Gnarrenburg TArosubsleesmhobotliyngInstructions Nut can be adjusted and retightened to ensure the cable is at back of product when assembled. UK Manufacturer: BH17 7BY EU Manufacturer: Brilliant AG, Brilliantstrasse 1, D-27442 Gnarrenburg