Battery Backup Cover Replacement
These instructions are written assuming that you will have ample room around the opener to perform this repair. Some rare instances will require removal of the unit from its mounting hardware and repair made on a bench or floor. Refer to your Owners Manual/Installation Poster for proper assembly and carefully read and understand all warnings and cautions pertaining to your unit.
Warnings
WARNING: BE SURE ELECTRICAL POWER HAS BEEN DISCONNECTED FROM THE INPUT POWER LINES PRIOR TO REMOVING THE MOTOR COVER.
WARNING: ANY AND ALL REPAIRS MADE TO THIS UNIT MUST BE PERFORMED WITH THE DOOR DISCONNECTED FROM THE OPENER AND IN THE CLOSED POSITION.
Important Notes
Proper care should be used when handling a battery. Eye protection should be worn.
NOTE: DO NOT reverse polarity (+) and (-) as this will damage the powerhead.
Replacement Steps
- Close door.
- Unplug powerhead from power source.
- Unplug battery backup from harness connection. (Refer to Fig. 1)
- Remove both mounting screws from the rear of the battery backup. (Refer to Fig. 1)
- Detach battery backup from the back of the opener by tilting the BBU approximately 45 degrees and lifting upwards towards the ceiling. (Refer to Fig. 1)
- Remove 4 screws from the battery hold-down bracket. (Refer to Fig. 2)
- Install battery and battery hold-down bracket onto the replacement cover.
- Install battery backup assembly onto operator in reverse order.
Diagrams
Figure 1: Battery Backup Unit Attachment
This figure illustrates the battery backup unit (BBU) connected to the garage door opener mechanism. It shows the BBU tilted at approximately a 45-degree angle relative to the opener's main housing, with mounting screws indicated at the rear of the unit. The connection harness is also visible.
Figure 2: Battery Backup Components
This figure displays the battery backup unit (BBU) and its associated components. It shows the battery itself, the protective casing, the connection harness, and the battery hold-down bracket, which is secured by four screws.
Safety Information
CAUTION: TO PREVENT POSSIBLE SERIOUS INJURY or DEATH from electrocution AND REDUCE RISK of FIRE
- Disconnect ALL electric power sources and battery power BEFORE performing ANY service or maintenance.
- Install only in DRY locations - NOT INTENDED FOR OUTDOOR USE.
- Use only 12V, 5AH, SLA replacement battery (P/N 111658.0002.5).
ATTENTION: POUR ÉVITER LES BLESSURES GRAVES VOIRE MORTELLE PAR ÉLECTROCUATION POUR RÉDUIRE LES RISQUES D'INCENDIE
- Débrancher toutes les sources d'alimentation électriques et la pile avant d'effectuer des opérations de réparation ou d'entretien.
- Installer uniquement dans des endroits secs - NE DOIT PAS ÊTRE UTILISÉ À L'EXTÉRIEUR.
- Utiliser uniquement une pile de remplacement de 12V,5AH, SLA (réf. 111658.0002.5).
Document identifier: 39569503428 | Revision Date: 10/2016
