Introduction
Welcome to the Solos AirGo 3 smartglasses. This manual provides comprehensive instructions for setup, operation, and care.
Manufacturer: Solos Technology Limited
Website: www.solosglasses.com
E-shop: store.solosglasses.com
Getting Started
Powering On and Off
Before powering on, ensure the left and right temples are securely attached to the frame.
To power on, press and hold the Virtual Button on the right temple for 2 seconds. The LED will flash blue, and the device will automatically reconnect to the last paired phone.
To power off, press and hold the Virtual Button on the right temple for 8 seconds until the "Power Off" prompt is heard and the LED turns off.
Bluetooth Pairing
Turn on Bluetooth on your phone and place the AirGo 3 nearby.
In your phone's Bluetooth settings, select "Solos AirGo 3 xxxx" (xxxx represents the device number).
To clear pairing history, press and hold the Virtual Button on the right temple for 8 seconds until the LED flashes red/blue and a "Pairing" prompt is heard, followed by two beeps.
The AirGo 3 LED flashes blue when paired and ready for calls and music.
Controls and Features
Audio and Call Management
Touch Sensor:
- Single Tap: Play/Pause Music
- Slide: Adjust Volume, Accept/Reject Calls
- Double Tap: Activate Voice Assistant
Virtual Button:
- Long Press: Pairing, Power On/Off, End Call, Next Song
Volume Control
To increase volume, slide backward on the touch sensor on the right temple.
To decrease volume, slide forward on the touch sensor on the right temple.
Voice Assistant
Double-tap the frame to activate your phone's voice assistant (iOS or Android).
Music Control
Single-tap the frame to play or pause music.
Press and hold the Virtual Button on the right temple for 2 seconds to play the next track.
Phone Calls
To accept a call, slide towards the ear on the right temple.
To decline a call, slide away from the ear on the right temple.
To end a call, press and hold the Virtual Button on the right temple for 2 seconds.
To accept a second incoming call, press and hold the Virtual Button on the right temple for 2 seconds; the current call will end.
Charging
Method 1: Connect the pogo pin connectors of the dedicated charging cable to the AirGo 3 charging port.
Method 2: Connect the Type C charging cable to the AirGo 3's left temple charging port.
Plug the USB connector of the charging cable into a USB charger or laptop.
The LED is red during charging and turns blue when fully charged. The device automatically powers off while charging.
Mobile App and Warranty
Solos AirGo App
The AirGo mobile app is available for iOS and Android. It provides AI Care (health monitoring, posture/stretching exercises, reminders) and AI Coach (jogging activity analysis and coaching).
Warranty Registration
Complete warranty registration to receive Solos services, product updates, and special promotions.
Method 1: Download the Solos AirGo App, navigate to 'Settings', and select 'Warranty Registration'.
Method 2: Scan the provided QR code to complete registration.
LED Status Indicators
- Blue flashing every 2 seconds: Waiting for Bluetooth connection
- Blue flashing every 1 second: Bluetooth connected
- Red/Blue flashing: Pairing
- Fast Red/Blue flashing: Receiving incoming phone call
- Red: Charging
- Blue: Fully Charged
Safety and Regulatory Information
Safety Warnings
- To prevent possible hearing damage, do not listen at high volume levels for extended periods.
- Use the product at a comfortable, moderate volume level.
- Turn the volume down before wearing the glasses or placing them near your ears, then gradually increase to a comfortable level.
- Use caution while driving and adhere to applicable laws regarding mobile phone use.
- Focus on your safety if using the product while engaged in activities requiring attention, such as walking in or near traffic, construction sites, or railroads.
- Do NOT use the product if it emits any unusual noise. Turn it off and contact Solos customer service.
- Do NOT submerge or expose the product to water, or wear while participating in water sports (e.g., swimming, surfing).
- Remove the product immediately if you experience a warming sensation or loss of audio.
- Keep the product away from fire and heat sources. Do NOT place flame sources on or near the product.
- Do NOT make unauthorized alterations to this product.
- Use this product only with an agency-approved power supply that meets local regulatory requirements.
- Do NOT wear the product while charging.
- After each use, wipe all parts of the frame with the provided pouch bag or a dry cloth.
- After charging is complete, unplug the charging cable from the USB port.
Caution: Contains magnetic material that may interfere with medical devices. Consult a physician before use.
Regulatory Compliance
This product complies with EU Directive 2014/53/EU and other applicable EU directive requirements. The complete declaration of conformity can be found at: www.solosglasses.com/compliance.
FCC Regulatory Conformance
This device complies with Part 15 of the FCC Rules. Operation is subject to two conditions: (1) it may not cause harmful interference, and (2) it must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
If this equipment causes harmful interference to radio or television reception, try to correct it by reorienting the receiving antenna, increasing separation, connecting to a different circuit, or consulting a dealer/technician.
The manufacturer is not responsible for interference caused by unauthorized modifications.
The SAR limit adopted by FCC is 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported to the FCC for this device type complies with this limit. The highest SAR value reported to the FCC for this device type when using in portable exposure conditions is 0.28 W/kg.
EU Regulatory Conformance
RF exposure information indicates the device's EIRP power is below exempt conditions as specified in EN62479:2010. RF exposure assessment confirms no harmful EM emission above reference levels.
Other Regional Compliance
Taiwan Regulatory: Complies with low-power radio-frequency device technical specifications.
Thailand Regulatory: This telecommunications equipment complies with the standards or technical requirements of the NBTC (National Broadcasting and Telecommunications Commission).
This product is TELEC certified and safe. TELEC ID: R 210-163535.
Disposal Information
This symbol ♻️ indicates the product must not be disposed of as household waste. Dispose of waste equipment separately from municipal waste to prevent negative environmental and health consequences.
Caution: Do not attempt to remove the rechargeable lithium-ion battery ?.
Please recycle batteries ? (Li-ion).
Lens Information
For Sunglasses Lens:
- Not suitable for driving in twilight or at night.
- EU FILTER CATEGORY: ISO 12312-1 CAT 3
- Provides high protection against sunglare and good UV protection (UV400 cut).
For Optical Lens:
- EU FILTER CATEGORY: ISO 12312-1 CAT 0
- Very limited sunglare reduction.
- UV rating: UV400 cut.
- Not for direct observation of the sun.
- Not for protection against artificial light sources (e.g., solaria).
- Not for use as eye protection against mechanical impact hazards.
