User Guide for AUTEL models including: XLINKDC2221, WQ8-XLINKDC2221, WQ8XLINKDC2221, 6206107 MaxiFlash XLink Vehicle Communication Interface, MaxiFlash XLink Vehicle Communication Interface, Vehicle Communication Interface
Autel Intelligent Tech. Corp., Ltd. XLINKDC2221 MaxiFlash XLink WQ8-XLINKDC2221 WQ8XLINKDC2221 xlinkdc2221
Autel Intelligent Tech. Corp., Ltd. XLINKDC2221 WQ8-XLINKDC2221 WQ8XLINKDC2221 xlinkdc2221
File Info : application/pdf, 6 Pages, 1.23MB
DocumentDocumentA B c D B 2 3 4 5 6 7 8 FCC STATEMENT : FON DATE DESCRJPTION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and A (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against B harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: c Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 1-- Consult the dealer or an experienced radio/TV technician for help. RF warning statement: This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. This device should be installed and operated D with minimum distance 20cm between the radiator & your body. IC STATEMENT - English: " This device complies with Industry Canada licence-exempt RSS standard( s). Operation is subject to the following two conditions: (1) this device may not cause interference, and B (2) this device must accept any interference, including interference that may cause undesired operation of the device." - French:" Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil nedoit pas produire de brouillage, et F (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement." 2 3 4 5 6 7 8Microsoft: Print To PDF