User Guide for UNI-T models including: UT372D 2 in 1 Tachometer, UT372D, 2 in 1 Tachometer, Tachometer

UT372D英文快速指南 UT372D英文快速指南

admin

UT372D 2-in-1 Tachometer - UNI-T Meters | Test & Measurement Tools and Solutions

UT372D | Quick Start Guide - UNI-T Meters | Test & Measurement Tools and Solutions

• Google Docs
• Google Drive
• Download [pdf]
• Download Optimized



File Info : application/pdf, 1 Pages, 4.27MB

Document Document

P/N:110401111330X

UT372D 2 in 1 Tachometer Quick Start Guide
UT372D is a tachometer that has contact and non-contact RPM measurement modes. Here is a quick start guide for this product.

1. Battery Installation a) Loosen the quick release screw on the rear
housing and remove the battery cover; b) Install the new batteries and be sure that the
polarity is correct; c) Close the battery cover and tighten the quick
release screw.

4. Non-Contact---RPM/Hz a) Loosen the quick release screws of the
mechanical adapter and remove the adapter; b) Cut a piece of 10mm*10mm reflecting tape and
stick it on the measured object, and tear off the film on the surface of the reflecting tape. c) Turn on the tachometer > Select the non-contact measurement mode > Select the unit RPM or Hz; d) Press the Measure button to turn on the laser. Point the laser vertically at the reflecting tape and start measuring.

2. Contact---RPM/Hz a) Install the mechanical adapter and tighten the
quick release screws; b) Install the cone/internal cone shaft contact; c) Turn on the tachometer > Select the contact
measurement mode > Select the unit RPM or Hz; d) Make the shaft contact closely contact with the object to be measured and start measuring.
3. Contact---Surface Velocity/Length Measurement
a) Install the mechanical adapter and tighten the quick release screws;
b) Install the contact wheel (0.1m/6in); c) Turn on the tachometer > Select 0.1m or 0.6in
according to the contact wheel used > Select the surface velocity unit (m/min, in/min, ft/min) or length unit (m, in, ft); d) Make the contact wheel closely contact with the object to be measured and start measuring.

5. Non-Contact---REV
a) Loosen the quick release screws of the mechanical adapter and remove the adapter;
b) Turn on the tachometer > Select the non-contact measurement mode > Select the unit REV;
c) Press the Measure button to turn on the laser. Point the laser vertically at the passing objects and start counting.