Pamray 47 Inch Desk Assembly

Step 1: Initial Frame Assembly

⚠ Attention:

Please ensure the holes in the middle section of one side of the two 'A' parts are kept on the same side. This is crucial for facilitating the installation of the X-shape brace.

Parts Required:

• A4 (x1)
• X8 (x8)
• X1 (x1)
• X22+1 (x1)
• X9+1 (x1)
• X1 (x1)
• X1 (x1)

Diagram Description: This step illustrates the basic desk frame structure. Two vertical support pieces, labeled 'A', are shown. These pieces have specific pre-drilled holes in their middle sections, which are essential for attaching the X-shape brace. The overall configuration depicts the initial skeleton of the desk.

Step 2: Attaching the X-Shape Brace

⚠ Attention:

The X-shape brace has two sides. If you encounter resistance or feel the assembly is not smooth, please flip the brace to the other side and attempt installation again.

Parts Required:

• X4 (x4)
• X4 (x4)
• X1 (x1)
• X1 (x1)

Diagram Description: This step shows the desk frame with the X-shape brace being attached. The brace is positioned diagonally, crossing between the two vertical supports. Screws are indicated for securing the brace. The visual emphasizes the correct orientation and alignment for smooth assembly.

Step 3: Optimizing Stability with Damping Nuts

Feature: Damping nuts optimize the stability of the desk.

⚠ Attention:

When tightening screws with a hexagonal screwdriver, it is essential to simultaneously use the included wrench to hold the damping nut in place. Without this step, the screw will not be properly tightened, compromising stability.

Diagram Description: This illustration provides a close-up view of the damping nut assembly. It demonstrates how a screw is inserted and tightened using a hexagonal screwdriver, while a wrench is simultaneously used to secure the damping nut. This highlights the correct technique for achieving optimal stability.

Step 4: Assembling the Desk Base

Parts Required:

• X6 (x6)
• X1 (x1)

Diagram Description: This step shows the assembly of the desk base. The base panel is being connected to the main desk frame, likely the vertical supports and the bottom of the X-brace, using screws.

Step 5: Final Assembly and Attachments

Parts Required:

• X4 (x4)
• X4 (x4)
• X1 (x1)
• X1 (x1)

Contact Information:

For assistance, please email: pamrayservice@gmail.com

Diagram Description: This diagram displays the fully assembled Pamray 47 Inch Desk. The X-shape brace is correctly installed, and the desk is shown complete with its top surface. The illustration indicates the final screw placements and also features an attached storage bag, demonstrating the finished product.