User Manual for JCHR models including: JCHR35W1B, JCHR35W2B, JCHR35W1B 6-Channel LCD Remote Controller with Timer, JCHR35W1B, 6-Channel LCD Remote Controller with Timer, 6-Channel LCD Remote Controller, LCD Remote Controller, Remote Controller, Controller
The transmitter should not be exposed to moisture or impact, so as not to affect its life During use, when the remote control distance is significantly shorter or less sensitive, please check whether the battery needs to be replaced. When the battery voltage is too low, the LED screen will show a low voltage prompt, prompting to replace the battery. Please properly dispose of used batteries ...
JCHR35W1B/W2B(new) User Manual 01 Product Info JCHR35W1B(new) JCHR35W2B(new) Wall-mounted 6-channel LCD 02 Models & Parameters (more info please refer to the nameplate) 03 Caution! 1. The transmitter should not be exposed to moisture or impact, so as not to affect its life 2. During use, when the remote control distance is significantly shorter or less sensitive, please check whether the battery needs to be replaced. 3. When the battery voltage is too low, the LED screen will show a low voltage prompt, prompting to replace the battery. 4. Please properly dispose of used batteries according to the local garbage classification and recycling policy. 04 Instructions a.Channels & Groups Toggling JCHR35W1B(new) Prg JCHR35W2B(new) Wall-mounted 6-channel LCD Channel 0 is where all channels are shown as steady-lit. b.Number of Channels Setting c.Number of Groups Setting d.Channel in Group Setting Short press , if you want the Channel in the group, the Channel number will be steady-lit. Short press again, if you want the Channel not in the group, the Channel number will be flashing. e.Check the Channels in Groups f.Prohibit Dual-key Operation g.Position Percent Setting h.Timer Function On/Off i.Local Time Setting Under Timer Off Mode j.Timer Control Enter program mode Stop on the desired percentage down and wait 3s. The shades will move to the chosen percentage down position. Program 1 Program 2 Program 20 Steady-lit channel numbers will be inclueded in the timer program; flashing channel numbers will not included in the timer program. Steady-lit channel numbers will be inclueded in the timer program; flashing channel numbers will not included in the timer program. k.Default Setting invalid l.For other operations, pls refer to the motor operation instruction Set Up hour Set Up minute Set Down hour percentage Set Down minuteAdobe PDF library 16.07