Instruction Manual for JAXPETY models including: All-Terrain Knee Scooter with Basket and Dual Braking System, Scooter with Basket and Dual Braking System, Basket and Dual Braking System, Dual Braking System, Braking System
26 feb 2023 — Insert the rear wheels into the mainframe and make sure the holes are aligned. 2.Insert the screw into the hole and secure the “star bolt”.
All-Terrain Knee Scooter with Basket & Dual Braking System| Jaxpety
File Info : application/pdf, 2 Pages, 1.04MB
DocumentDocumentPULL BACK TO SLOW DOWN PUSH FORWARD TO BRAKE Hand Brake Lock Brake Cable Removable Storage Bag Front Wheel Handle Lifting Lever Knee Pad Star Bolt Rear Wheel Body MAINTENANCE 1. The exterior of this rollator walker should be cleaned periodically with a soft damp cloth. Do not use abrasive cleaners or caustic chemicals. 2. Check the parts for any looseness, wear, or damage periodically. If any problems are found, correct them before using them. 3. If haven't used it for a long time, store it in a cool,dry, and safe place. ASSEMBLY INSTRUCTIONS PART LIST Rear wheel Mainframe Knee pad Bag A x2 B x1 C x2 Star bolt / Screw Star screw Bag screw Installation tool 1 STEP ROLLATORS POLE INSTALLATION Open the mainframe and lock the lever If you find the frame is unsteady, please tighten the screw 1. 2. 3. 2 1 4. 5. 2 STEP REAR WHEELS INSTALLATION 1.Insert the rear wheels into the mainframe and make sure the holes are aligned 2.Insert the screw A into the hole and secure the "star bolt" 1. 2. 3. 4. 3 STEP LIFTING LEVER INSTALLATION 1.Insert the lifting lever into the mainframe 2.Adjusting the suitable height, then make sure the holes are aligned 3.Insert the star bolt B into the hole and tighten it 4.Attach the Card buckle to the lifting rod 1. 2. 3. 4. 5. 4 STEP KNEE PAD INSTALLATION 1.Insert the knee pad into the tube 2.Adjusting the suitable height , then make sure the holes are aligned 3.Insert the screw A into the hole and secure the star bolt 1. 2. 3. 5 STEP BAG INSTALLATION Make sure the holes are aligned, then insert the screw C into the hole and secure the nut with a tool, 1. 2. 3.