Instruction Manual for sonic models including: MSS Plus 8 Drawers with Storage, MSS Plus, 8 Drawers with Storage, Drawers with Storage, Storage
11 apr 2024 — If the cabinet is equipped with a power supply, feed the cable through the back of the cabinet and ensure this has been done before placing any new modules.
MSS+ INSTALLATION INSTRUCTIONS · Before you start the installation, check whether you have enough space. · If you place a module with drawers, please remove some of the drawers to assemble the posts and connect the cabinets to each other. · Remove the locking pin on the left and right frontside of the drawer rail, in order to lift the drawer from the rails. · If the cabinet is equipped with a power supply, feed the cable through the back of the cabinet and ensure this has been done before placing any new modules. · The next step is to place the posts on the back of the cabinet. Always do this before placing any new modules. · When the module is in place, level it with the adjustable feet at the bottom of the cabinet. Ensure this has been done in the width and length of the cabinet. · After placing the second cabinet, both cabinets can be joined by a bolt, two washers and a nut on the top inside of each cabinet. Please do this with every following cabinet. · Remove the rubber washers from the rear of each post. Then place the Allen screws on the narrow side of each post. · To continue, hang the back panels on the screws and slide down to lock. · Place the Allen screws on the top side of the posts. Attach the cupboard and insert the Allen screws on the bottom side of the cupboard. · When placing several cupboards, connect them to each other from the inside of the cupboards. · Finally, you tighten the posts to the inside of the cabinets. · Let's mount the top blade. If you have chosen a stainless-steel top blade, mount these with the screws from the inside of the cabinets. · In case of a composite top, the blade can be glued on top of the cabinets. · It's time to replace the drawers. Retract the drawer rails 100% and lock them in place. Do this on both the left and right side. · Then slide the drawer on the mounting hook on the back of the drawer rails. Then lower the drawer in the upwards mounting hooks on the front side. Finally replace the locking pins and repeat this process for every drawer. · MSS+ is fully compatible with our Sonic Foam System, we have the perfect toolset for every drawer. · All modules are equipped with a 4-digit combination lock. These can be set with a personal code. We wish you success with your premium MSS+ workplace. If you have any questions, our Support Team is there to help. SONICTOOLSUSA.COMAdobe PDF Library 17.0 Adobe InDesign 19.3 (Macintosh)