Home & Kitchen Appliances | Sunbeam
Home & Kitchen Appliances | Sunbeam
User Guide for Sunbeam models including: BLE4821 Single, BLE4841 Double, BLE4851 Queen, BLA6321 Single, BLA6331 King Single, BLA6341 Double, BLA6351 Queen, BLA6371 King, BLQ6421 Single, BLQ6451 Queen, BLQ6471 King, BLQ6481 Super King, BLW6651 Queen, BLW6671 King, BLW6681 Super King, BLE4800 Series Electric Blankets, BLE4800 Series, BLE4800 Series Blankets, Electric Blankets, Blankets
12 pagine
File Info : application/pdf, 12 Pages, 2.64MB
DocumentDocumentElectric Blankets User Guide Sleep Express Range: BLE4821 (Single), BLE4841 (Double), BLE4851 (Queen) Sleep Perfect Antibacterial Range: BLA6321(Single) BLA6331 (King Single) BLA6341 (Double) BLA6351 (Queen) BLA6371 (King) Sleep Perfect Quilted Range: BLQ6421 (Single), BLQ6451 (Queen), BLQ6471 (King), BLQ6481 (Super King) Sleep Perfect Wool Fleece Range: BLW6651 (Queen), BLW6671 (King), BLW6681 (Super King) Contents Sunbeam's Safety Precautions 1 Safety Precautions for your Electric Blanket 2 Features of your electric blanket 3 Fitting your electric blanket 4-5 Your 6 heat control 6 Troubleshooting 7 Care and cleaning 8 Sunbeam's Safety Precautions Sunbeam is very safety conscious when designing and manufacturing consumer products, but it is essential that the product user also exercise care when using an electrical appliance. Listed below are precautions which are essential for the safe use of an electrical appliance: · Read carefully and save all the instructions provided with an appliance. · Always turn the power off at the power outlet before you insert or remove a plug. Remove by grasping the plug - do not pull on the cord. · Turn the power off and remove the plug when the appliance is not in use and before cleaning. · Do not use your appliance with an extension cord unless this cord has been checked and tested by a qualified technician or service person. · Always use your appliance from a power outlet of the voltage (A.C. only) marked on the appliance. · This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. · Children should be supervised to ensure that they do not play with the appliance. · The temperature of accessible surfaces may be high when the appliance is operating. · Never leave an appliance unattended while in use. · Do not use an appliance for any purpose other than its intended use. · Do not place an appliance on or near a hot gas flame, electric element or on a heated oven. · Do not place on top of any other appliance. · Do not let the power cord of an appliance hang over the edge of a table or bench top or touch any hot surface. · Do not operate any electrical appliance with a damaged cord or after the appliance has been damaged in any manner. If damage is suspected, return the appliance to the nearest Sunbeam Appointed Service Centre for examination, repair or adjustment. · For additional protection, Sunbeam recommend the use of a residual current device (RCD) with a tripping current not exceeding 30mA in the electrical circuit supplying power to your appliances. · Do not immerse the appliance in water or any other liquid unless recommended. · Appliances are not intended to be operated by means of an external timer or separate remote control system. · This appliance is intended to be used in household and similar applications such as: staff kitchen areas in shops, offices and other working environments; farm houses; by clients in hotels, motels and other residential type environments; bed and breakfast type environments. · Do not place heavy items on top of the appliance when it is turned on. · It is recommended that a qualified engineer or registered person inspect the heated blanket once it passes warranty period and every 2 years thereafter. If you have any concerns regarding the performance and use of your appliance, please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line. Ensure the above safety precautions are understood. 1 Safety Precautions for your Electric Blanket · Do not use your electric blanket on or under a waterbed. · Do not use on an adjustable bed or futon. · Do not switch the blanket on if moist or wet. · Do not allow the blanket heating wires to lie over the edge of the mattress. · Do not place your power cord or connector under any stress or strain. Never jam or bend the power cord over a hard surface such as a bed frame. The power cord should always remain free from obstructions. · Do not use pins, needles, safety pins or other sharp items on your electric blanket. · Do not dry clean your electric blanket. · Use only as an underblanket. · Examine periodically for signs of wear or damage on the blanket and on the blanket cords. If there are such signs, or the blanket has been misused, return it to an authorised service agent for inspection. · Each day check that the electric blanket is smooth, flat and properly secured on the mattress. Do not use if the blanket is folded, rucked or creased. · Only use your electric blanket with the controls supplied or marked equivalent. · Parents or guardians must preset the controls for young children, unless the child has been adequately instructed on how to operate the control safely. · Turn the power off and remove the plug when the appliance is not in use and before cleaning. · This electric blanket is not intended for use in hospitals. · Should your appliance suffer a thermal or fuse link rupture (normally identified when the blanket stops heating) please return it to the manufacturer or agent for repair or replacement. · When storing the appliance, allow it to cool down before folding. · Do not crease the appliance by placing items on top of it during storage. · Not to be used by very young children (0-3 years), infirm persons, or persons insensitive to heat. · This appliance must not be used by persons insensitive to heat and other very vulnerable persons who are unable to react to overheating. · Heat settings 1-3 are for continuous or all night use. If this appliance is slept on with the controls set to a higher temperature, the user may suffer skin burns or heat stroke. Important instructions retain for future use. If you have any concerns regarding the performance and use of your appliance, please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line. Ensure the above safety precautions are understood. Care Label Symbols Attention Instruction Booklet - Please read the instructions thoroughly before use 2 Features of your electric blanket Fitted design The 50cm fitted skirt and extra strong elastic cord keep the blanket flat and taut on the mattress, and make fitting easier. Machine washable The detachable controls and waterproof element make your electric blanket safe to machine wash and may be tumble dried. For Care and Cleaning instructions, see page 8. Detachable controls Always remove the controls when laundering your blanket. Store the controls during the summer months while your blanket remains on the bed as a comfortable underblanket. Dual controls Your Double, Queen, King and Super King size electric blanket features two controls for individual comfort. 3 Fitting your electric blanket Note: The electric blanket is designed to fit within the edges of your mattress (see Figure 1). This ensures the best, smoothest and firm fit of your blanket to the mattress. As the blanket settles in to the fit of the bed, any fold ridges should smooth out over time. Pull the fitted skirt over the top corners of the mattress. To fit the foot of the bed, pull from the centre of the blanket to the foot of the bed, and fit one corner at a time while holding the centre (see Figure 2). Place the electric blanket on your mattress with the control sockets on the underside of the blanket near the head of the bed (see Figure 1). Ensure the heating wires do not extend under the pillows. A single or king single electric blanket can be turned over so that the control is on the preferred side of the bed if desired. Please note that this may result in the control facing towards the bed once the bed is made. Figure 2. Ensure the fitted skirt is completely under the mattress. Pull on the edges of the blanket to ensure that it is flat and square on the mattress. Figure 1. 4 Fitting your electric blanket Connecting the controls To connect the controls, lift one corner of the blanket near the head of the bed to expose the connector socket (see Figure 3). Pass the control cord through the triangular hole in the fitted skirt and insert the connector plug into the socket. Ensure it is firmly clicked into position. Repeat on the other side if required. Plug the controls into a 230-240V power outlet and turn the power on. Note: Ensure that the controls are connected to the blanket before inserting the power cord into the power outlet. Connecting the power before attaching the controls to the blanket will replicate a power interruption and activate the safety system, preventing your blanket from heating. Caution: The cord and controls must be kept outside the bed and away from external heating sources such as heaters and lamps. Do not cover the control. Figure 3. Before first use Before using your electric blanket for the first time, Sunbeam recommends that you switch the blanket to maximum heat for two to three hours to evaporate any moisture in the mattress. Repeat this process every few months to maintain a dry, healthy bed. 5 Your 6 heat control Using your electric blanket Press the Power button to turn the blanket on. Your electric blanket is supplied with a 6 heat control. Press the temperature button to toggle through each heat setting. Safety Auto off Your electric blanket features a safety auto off with 1, 3 or 9 hours automatic stop, so you can choose the right warmth for you. Simply press the Power button to reactivate. 1 3 Continuous or all night use 4 5 Medium Pre-heat 6 Fast Pre-heat Use Pre-heat settings to preheat the electric blanket only. Note: When pressing the power button, the electric blanket will automatically turn to setting 6 (Fast Pre-heat). Heat Settings Timer Settings Power / Standby button 6 Troubleshooting Check the control is plugged into the electric blanket, and ensure it is clicked securely into position. If the control connector is not properly fitted to the blanket, switch the power off at the power outlet, securely attach the control connector plug to the blanket and then switch the power back on. Check the power cord is connected to the power outlet and that the power is switched on. The electric blanket is not heating If only one side of the blanket is working, it may simply be because the control rather than the blanket is not working. To help resolve your issue quickly, before calling Sunbeam Customer Service, please check the control. Simply swap the "good controller" to the "faulty" side of the blanket. Wait 20 minutes to see if the blanket is heating. If it does heat, the first controller is faulty. If the blanket still does not heat, the blanket may be faulty. Then call Sunbeam Customer Service line, and they will be able to assist. Remember for double and queen blankets there are 2 controls. Ensure both are plugged into the blanket, and both cords are plugged into a power outlet. If you are using a powerboard, use one with a safety cut out. Check to see if the powerboard is working, by plugging your blanket into a different powerpoint. The cord or any Do not attempt to repair it yourself. Contact the Sunbeam Customer service line wiring is damaged on 1300 881 861 in Australia or 0800 786 232 in New Zealand. 7 Care and cleaning All Sleep Express electric blankets feature waterproof heating elements, making them fully immersible and safe to wash by hand or machine. Before cleaning your electric blanket, ensure that the controls are unplugged from the blanket. Spot cleaning Sponge the affected area using a neutral wool detergent or mild soap flakes mixed with lukewarm water. Sponge twice with clean water to remove detergent. Remove excess water by compressing the wet area between two towels. Hand washing Wash the blanket in lukewarm water with a neutral wool detergent or mild soap flakes. Soak for five minutes, then gently squeeze the soapy water through the fabric. Rinse thoroughly in clean, lukewarm water then drain excess water from the blanket. Do not wring. Machine washing Take your electric blanket to a commercial laundry or wash in a domestic washing machine (permitting). Wash on WOOL or DELICATES cycle with a neutral wool detergent or mild soap flakes, below 40°C. Do not use high speed or extra spin cycles. 8 Line drying Drape the blanket across several lines of your clothesline, and try to avoid direct heat. Do not use pegs on the wired areas. Do not dry with a hairdryer or heater. Ensure that the blanket and control sockets are completely dry before using again. Machine drying Tumble dry your blanket on LOW setting for 15 minutes MAXIMUM. Smooth the blanket by gently pulling any creases out of the fabric. Line dry to ensure the blanket and control sockets are completely dry before use. Do not dry with a hairdryer or heater. Storing your blanket Your blanket can remain on the bed all year round as a comfortable underblanket. Simply remove the controls and store until winter. If you wish to remove the blanket from your bed when not in use, roll or fold it loosely and store in a blanket bag or the bag it was supplied in. Avoid pressing sharp creases into the blanket. Do not place heavy items on top of your electric blanket when storing. When storing the electric blanket, allow it to cool down before folding. 3 3 year Year Australia www.sunbeam.com.au 1300 881 861 Units 5 & 6, 13 Lord Street, BNoetwanZyeNaSlaWnd2019 Awuwswtr.asulina beam.co.nz 0800 786 232 New Zealand www.sunbeam.co.nz 0800 786 232 Level 6, Building 5, Central Park, 660-670 Great South Road, Greenlane, Auckland New Zealand 3 years Need help with your appliance? Contact our customer service team or visit our website for information and tips on getting the most from your appliance. Australia | visit phone www.sunbeam.com.au 1300 881 861 New Zealand | visit phone www.sunbeam.co.nz 0800 786 232 Newell Australia Pty Ltd. ABN 68 075 071 233 Sunbeam is a registered trade mark. Made in China to Sunbeam's specification. Due to minor changes in design or otherwise, the product you buy may differ slightly from the one shown here. Approved by the appropriate electrical regulatory authorities. ©Copyright Sunbeam 2022. SAP#: BLE: 2166633, 2166632, 2166617 BLA: 2181232, 2181242, 2181241, 2181237, 2181247 BLQ: 2181248, 2181240, 2181235, 2181244 BLW: 2181245, 2181238, 2181233 Part Number: NWL0001448899 2023 Blankets range IB_22EM1 (ANZ)_GCDS-LD