Instruction Manual for ENERLITES models including: 975501-C, 975501-S, 975501-C 4 Inch Dia Round Screw Cap Floor Box Cover with 20A Duplex Tamper and Weather, Dia Round Screw Cap Floor Box Cover with 20A Duplex Tamper and Weather, Floor Box Cover with 20A Duplex Tamper and Weather, Duplex Tamper and Weather

YB

https://enerlites.com/wp-content/resources/manuals 2023/Manuals2023Rebrand/IM 20230802 975501-S

Nickel-Plated 4" Cover Plate w TRWR Receptacle - ENERLITES

IM 20230802 975501-S
INSTALLATION INSTRUCTIONS
975501-C / 975501-S
4" Dia. Round Screw Cap Floor Box Cover with 20A Duplex Tamper & Weather Resistant Receptacle

4" (101.48mm)

WIRING DIRECTIONS
Insert wire(s) through terminal holes in the back, then tighten terminal screws.
· Connect HOT wire to the HOT terminal (brass screw).
· Connect NEUTRAL wire to the NEUTRAL terminal (silver screw). · Connect GREEN or BARE wire to the GROUND terminal (green
screw).

1/8"(2.54mm)

Cover Material
Flush round flip lid cover plate with duplex tamper & weather resistant receptacle. Includes one 20 amp duplex tamper & weather resistant receptacle, gasket and cover.
· Compact and stylish design in Brass(C) or Nickel-Plated Brass(S). Height of metal box is adjustable for ease of installation.
· Corrosion resistant hardware ensures long life span and reliable performance. Easy access to power when you need it. Close and lock the cover when not in use.
Read and understand these instructions before installing. This device is intended for s
circuit breaker or fuse(s) and make sure power is off before wiring the device. Use copper wire ONLY.
1

4"(101.48mm)
Cover Plate
Before Installation: Ensure there is sufficient depth & space below the sub-floor.
1. Trace outline of box on sub-floor. 2. Following the outline, cut the box shape without the ears completely through the
sub-floor 3. Remove knockout(s) for cables and use cable clamps or grommets to secure
wires to the metal box. 4. Secure the metal box to framing using wood screws. 5. Follow the wiring directions and connect the wires to appropriate terminals on the
receptacle. 6. Secure receptacle to metal box and install cover using provided screws.
SCREW
COVERPLATE
GASKET SCREW GASKET SUPPORT PLATE RECEPTACLE
METAL BOX (* FB-02: Sold Seperately)
2

Ground (Green or bare wire)

Neutral (White wire)

Hot (Black wire)

This device is warranted to be free of material and workmanship defects for 2 years from the date of purchase. Original receipt or proof of purchase from an authorized retailer must be presented upon warranty claim. ALL claims must be verified and approved by Enerlites, Inc. Warranties from other Enerlites products may vary. This warranty is nontransferable and does not cover normal wear and tear or any malfunction, failure, or defect resulting from misuse, abuse, neglect, alteration, modification, or improper installation. To the fullest extent permitted by the applicable state law, Enerlites shall not be liable to the purchaser or end user customer of Enerlites products for direct, indirect, incidental, or consequential damages even if Enerlites has been advised of the possibility of such damages. Enerlites' total liability under this or any other warranty, express or implied, is limited to repair, replacement or refund. Repair, replacement or refund are the sole and exclusive remedies for breach of warranty or any other legal theory.
CA, U.S.A.
0212200157-01 REV 20230802


Acrobat Distiller 4.0 for Macintosh