Rat Zapper Ultra Electronic Rat Trap Instructions

How to Use

1. Place a small amount of bait such as peanut butter on the back wall of the unit, away from the metal plates on the floor of the trap. Use a cotton swab, toothpick, or another tool to bait the trap to avoid transferring your scent.
2. Remove the battery cover. Insert 4 new "D" batteries and replace the battery cover.
3. Place the trap on a flat surface against a wall where rodent activity has been observed. Position the trap lengthwise with the entrance nearest to the wall.
4. Turn the main switch ON. A green light will blink once, indicating that the batteries are good and the trap is operational.
5. When a rodent is caught, the red light will flash once every 7 seconds. To dispose of the rodent, turn the unit OFF, remove the batteries, and dispose of the rodent. Bait the trap, insert the batteries, and turn the main switch ON. A rapid red flash indicates that the batteries no longer have sufficient power to kill a rodent. Replace with 4 new batteries. The old batteries can still be used for other products that require "D" batteries.

Visual Guide

The following images illustrate the setup and use of the Rat Zapper Ultra:

Image 1: Baiting the trap with peanut butter using a tool.

Image 2: Inserting batteries into the trap.

Image 3: Placing the trap against a wall.

Image 4: The trap positioned against a wall.

Image 5: Disposing of a caught rodent into a waste bin.