Instructions for motepro models including: Digi-Code Digicode Cloning Garage Gate Remote Control Opener Multicode, HT7, Digi-Code Coding Device, Digi-Code Coding

digicode

Michael

Digi-Code 1 Button Genuine Remote

• Google Docs
• Google Drive
• Download [pdf]
• Download Optimized
• Document:
  • References

File Info : application/pdf, 1 Pages, 529.72KB

Digi-Code Coding Instrucons Both Digi-Code and Mul-Code are electronically the same. MULTI-CODE Switches: UP for ON DIGI-CODE Switches: DOWN for ON
1. Open both the working original remote and the new remote to reveal two x 10 switch banks (L/H Bank = L/H Buon) on the circuit board or one bank of 10 switches for a single buon remote.
2. Copy the switches exactly when coding Mul-Code to Mul-Code or upside down when coding Mul-Code to Digi-Code.
If no working remote is available look to the receivers on the motor/s (these are generally grey rectangular boxes aached to the motor. Remove the inspecon panels to reveal the 10 switches. This will mainly be a Mul-code receiver. Follow the steps above once you have located the switches on the receiver.
www.remotepro.com.au



References

• Garage Door Remotes, Automation & Gate | Car Remotes | Free Shipping – Remote Pro