Home - MULTIVOICE
User Guide for MULTIVOICE models including: M2P, MV-PAC, ALZM2P, MV2P Wireless Coaching Intercom, Wireless Coaching Intercom, Coaching Intercom, Intercom
Multi-Voice Radio LLC M2P MV-PAC ALZM2P ALZM2P m2p
File Info : application/pdf, 3 Pages, 395.16KB
DocumentDocumentUse Included USB-C cables and wall charger Plug USB-C cable into the Bottom of the PAC. There will be a "click" when fully inserted. The PAC is charging when · Pulsing Red. · Pulsing Red and Green Solid Green Light indicates Charge is complete Thing to check: · One Unit has a "M" in the status area. Only one PAC has the "M". · Stay within line of sight with all Units. · Check that battery level is above 10%. · Bend the mic boom so it is rotated down far enough to activate the mic. Solutions: 1) Turn off the Unit with the issue. Turn it back on again. This can be done when the system is in use. 2) Reset the entire system. Make sure all Units are off before turning back on. Product Description The Multi-Voice Radio combines conference communication with wireless radio. This full duplex system allows hands free communication on a secure signal with a easy to use design Measurements Length: 3.5 in Height: 1.4 in Width: 2.4 in Weight: 20 oz Signal Frequency: 902-928 MHz Frequency Hopping Spread Spectrum Output Power: Over 500mW Range: Up To 3/4 Mile Line of Sight Proprietary Encryption Battery 10 Hour Operation Temp: -20c +60c Rechargeable Lithium-polymer 1600 mAh UL1642, Compliance to US/CANADA This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device does not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa tion. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful inter ference to radio communications. However, there is no guarantee that interference will not occur in a particular installa tion. If this equipment does cause harmful interference to radio or television recep tion, which can be determined by turning the equipment off and on, the user is en couraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the re ceiver is connected. · Consult the dealer or an experienced radio/TV technician for help. Warning: Changes or modifications made to this equipment not expressly approved by Multi-Voice Radio may void the user's authority to operate the equipment. This Class B digital device complies with Canadian ICES-003. Cet appareil numerique de la classe B est conforme a la norme NMB-003 du Canada. Le present appareil est conforme aux CNR d'lndustrie Canada applicables aux appa reils radio exempts de licence. L'exploitation est autorisee aux deux conditions suiva ntes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioelectrique subi, meme si le brouillage est suscepti ble d'en compromettre le foncti onnement. FCC ID:ALZM2P IC: Model : MV2P MULTIVOICE Standard Quickstart Guide ·-·x:z. ->)) ..., MV-PAC Beltpack & Headset Industrial/Sports BUTTONS usb-c MULTIVOICE, MV-ONE,and the MULTIVOICE marks and logos are each trademarks of MULTIVOICE. (800)-604-0737 I www.MULTIVOICE.com I © MULTIVOICE 2016 I R1.0 2023 FCC Caution This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. FCC RF Exposure Information and Statement The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types MV-Pak(FCC ID: ALZM2P) has also been tested against this SAR limit. The highest SAR value reported under this standard during product certification for use at the body is 1.546W/kg. This device was tested for typical body-worn operations with the back of the handset kept 0mm from the body. To maintain compliance with FCC RF exposure requirements, use accessories that maintain a 0mm separation distance between the user's body and the back of the handset. The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements, and should be avoided. IC Caution: This device complies with Industry Canadas licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux apparei ls radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes: brouillage est susceptible d'en compromettre le fonctionnement. >ZZ ZZZ&> ZZZZZZ