Instructions for Shenzhen Daciot Technology models including: 20, 2A58M-20, 2A58M20, 2A58M-20 Bluetooth Speaker, 2A58M-20, Bluetooth Speaker
Shenzhen Daciot Technology Co.,Ltd 20 2A58M-20 2A58M20 20
Product Instructions Product specification Input voltage5V Input Current: 20mA Usage time: 8 hours Charging time: 90 minutes Bluetooth effective distance: 1.0 meters Supported system: IOS13.6/Android5.0 or above Indicator light description Status indicator Blue light flashes: waiting for bluetooth pairing status Blue light keeps on for 3 seconds: bluetooth connect successfully Battery indicator Red light flashing: low battery, please charge the device Steady green light: The device is fully charged Instructions Press the two virtual buttons at the same time for 6 seconds to power on the devicethe blue light flasheswaiting for bluetooth to connect; Turn on phone settingsfind the device "SO+" at the bluetooth listand connect it NOTEApple phone needs to turn on the auxiliary touch function settings-accessibility-touch-assistive touch-open Mode switch Long press the up button for six seconds,the light flashes once means video mode,twice means novel mode,default mode is video mode; Video mode Click the down button: Video page down Click the up button: Video page up Press the down button for two seconds: take a photo Double click the up button quickly: like video novel mode Click the down button: novel page down Click the up button: novel page up Press the down button for two secondsthe song pause/play Double click the up button quickly:switch to the next song Power off Long press the two buttons for 6 seconds to power off the device, the red light flashes once Standby mode If the device is idle for 20 minutes, it will automatically enter the standby mode. To resume the device, the device then will automatically connect to the last paired mobile phone FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.