1. Photographs of Conducted Emissions Test Configuration
This section shows the physical setup for conducted emissions testing.
Front view
A photograph shows a laboratory bench with a yellow surface and metal legs. A white electronic device is placed on the bench. Cables are connected to the device and run towards the back. In the background, other electronic equipment and cables are visible.
Side view
This photograph captures the setup from a side angle. The white electronic device is visible on the yellow bench. Power cables and other connections are seen. The surrounding environment appears to be a testing facility with metal walls.
Under table view
A view from underneath the testing bench. Various electronic measurement devices and power supplies are arranged on the floor or lower shelf, connected by numerous cables.
2. Photographs of Radiated Emissions Test Configuration
This section details the test configuration for radiated emissions, covering frequencies from 30MHz to 1GHz and above 1GHz.
Front view (30MHz~1GHz)
The image displays a device placed on a white, foam-like platform within an anechoic chamber. The chamber walls are covered with RF absorbing pyramidal foam. The device is connected via cables. A directional antenna is visible in the background.
Rear view (30MHz~1GHz)
This view shows the setup from the rear within the anechoic chamber. The white device on the foam platform is visible, along with its connections and the surrounding RF-absorbent walls.
Front view (above 1GHz)
Another photograph within an anechoic chamber. A white device is positioned on a similar foam platform. The setup is viewed from the front, showing the device and its connections against the backdrop of RF-absorbing panels.
Rear view (above 1GHz)
The rear perspective of the radiated emissions test setup for frequencies above 1GHz. The device, platform, and anechoic chamber environment are depicted.
