IKEA LAGAN Wall Mounted Extractor Hood

About this Manual

This manual provides essential information for the safe installation, operation, and maintenance of your IKEA LAGAN wall-mounted extractor hood. Please read it carefully and keep it for future reference. For assistance, refer to the last page for IKEA Authorized Service Centre contact details.

Safety Information

Before First Use

Your safety and the safety of others are paramount. Remove all protective packaging materials. Check the appliance for any transport damage. Do not place weights on the appliance and avoid exposure to atmospheric agents.

Important safety warnings are indicated by an attention symbol (⚠️) and specific terms like DANGER (indicates a hazardous situation which, if not avoided, will cause serious injury) and WARNING (indicates a hazardous situation which, if not avoided, could cause serious injury). Always follow these warnings to reduce the risk of injury, damage, or electric shock.

Precautions and General Recommendations

• Electrical installation and connection must be performed by a qualified technician according to manufacturer instructions and local safety regulations. Do not attempt repairs unless specified in the manual.
• Disconnect the appliance from the power supply before any installation work.
• WARNING: Incorrect installation of fixing devices may lead to electrical hazards.
• Earthing is compulsory (unless identified as Class II by the symbol ⌽ on the dataplate).
• Do not pull the power cable to unplug.
• Electrical components should not be accessible after installation.
• Do not touch the appliance with wet body parts or operate barefoot.
• Children aged 8+ and persons with reduced physical, sensory, or mental capabilities or lack of experience may use the appliance under supervision and with understanding of hazards. Children must not play with the appliance, nor perform cleaning/maintenance without supervision.
• All other maintenance must be done by a specialized technician.
• When drilling walls, be cautious of electric connections and pipes.
• Air vents must discharge to the outside.
• The manufacturer is not responsible for damage from improper use or incorrect settings.
• Regular cleaning and maintenance are crucial for performance. Clean filters monthly to remove oil and grease residuals.
• Never use free flames (flambé) under the hood; this can cause fire.
• Failure to clean the hood or replace filters correctly may result in fire.
• Exhaust air must not be vented through flues used for gas combustion appliances; use a separate outlet. Observe national regulations for fume extraction.
• Ensure adequate ventilation if using the hood with other gas/combustible appliances. Room negative pressure should not exceed 4 Pa (4x10-5 bars).
• Do not leave frying pans unattended when frying, as the frying oil may catch fire.
• Ensure light bulbs are cold before touching.
• Do not operate without a correctly fitted light bulb, as this may cause electric shock.
• The hood is not a work surface; do not place objects on top or overload it.
• Wear appropriate gloves during installation and maintenance.
• This appliance is not suitable for outdoor use.
• WARNING: Accessible parts of the hood may become hot when the hob is in use.

Installation and Connection

General

Contact the Authorized Service Centre for any problems. Remove the appliance from packaging only at the time of installation to prevent damage.

Preparing for Installation

WARNING: This is a heavy product; installation requires two or more people.

Maintain minimum distances between the hood and the hob: 65 cm for gas/other fuels, 50 cm for electric cookers. Check cooker manual for specific requirements. If the cooker instructions specify a greater distance, observe that.

Electrical Connection

Ensure the appliance's power voltage matches the mains voltage (check rating plate inside the hood). Power cable replacement (type H05 VV-F) requires a qualified electrician. If fitted with a plug, connect to an accessible, compliant socket.

WARNING: If direct wiring is used or the socket is inaccessible, a qualified electrician must install a standardised double pole power switch for complete isolation from the mains.

Use

The hood can be used for "Extraction installation" (venting air outside) or "Recirculation installation" (filtering and returning air indoors).

Extraction Installation

Cooking steam is channeled outside via a discharge duct (not supplied) connected to the hood's steam outlet. Ensure the duct is correctly fitted.

Important: Remove charcoal filters if already installed.

Recirculation Installation

Important: Ensure adequate air circulation around the hood.

Important: If charcoal filters are not supplied, they must be fitted before use. Filters are available at IKEA shops.

Install the hood away from dirty areas, windows, doors, and heat sources.

Wall fixing accessories are not included as wall materials vary. Use appropriate fixing systems for your walls and the appliance's weight. Consult a specialized dealer for details.

Keep this booklet for future consultation.

Product Description

Diagram Description: The hood features a Control Panel (1), Grease Filter (2), and Lighting Unit (3).

Control Panel

Buttons:

• A: Light ON/OFF
• B: ON/OFF / Extraction Power 1 selection
• C: Extraction Power 2 selection
• D: Extraction Power 3 selection

Cleaning and Maintenance

WARNING: Never use steam cleaning equipment. Always disconnect the power supply before cleaning.

IMPORTANT: Do not use corrosive or abrasive detergents. Clean spills immediately with a damp cloth.

Clean surfaces with a damp cloth. For heavy dirt, add a few drops of dish soap to water and finish with a dry cloth.

IMPORTANT: Do not use abrasive sponges or metallic scrapers, as they can damage the surface.

Use detergents specifically designed for the appliance and follow manufacturer instructions.

IMPORTANT: Clean filters at least monthly to remove oil and grease.

Grease Filter Cleaning

The metal grease filter has unlimited life and should be washed monthly by hand or in a dishwasher (low temperature, short cycle). Dishwasher cleaning may dull the filter but does not affect its capacity.

Grease filter maintenance steps:

1. Unplug or disconnect the power supply.
2. Remove grease filters by pulling the spring release handle downwards.
3. After cleaning, remount filters in reverse order, ensuring full coverage.

Charcoal Filter Maintenance (Recirculation Installation)

Unlike traditional filters, this charcoal filter can be washed and reactivated.

Steps:

1. Disconnect power supply.
2. Remove grease filter.
3. If carbon filters are fitted, turn the central handle anti-clockwise to unlock and replace them.
4. Open filter shells, pull out circular mats, and fit new filters.
5. Refit grease filters.

Care and cleaning long life Charcoal filter: Wash and regenerate the anti-odour filter every 3-4 months (or more frequently with intensive use), up to a maximum of 8 regeneration cycles.

Regeneration procedure: Wash in dishwasher (max 70°C) or hand wash in hot water without detergents or abrasive sponges. Dry in oven (max 70°C for 2 hours) or at room temperature, standing vertically.

Lamp Maintenance

Disconnect power. Open extractor grille or remove grease filter. Replace damaged lamp with E14 3W max LED lamps only. Do not touch the lamp with bare hands.

Lamp Specifications

What to Do If...

Troubleshooting Table

Before Contacting Service

Try switching the appliance on again. If the problem persists, switch off and try again after an hour. If still unresolved, contact the Authorized Service Centre with details of the fault, model, serial number, and service number.

Technical Data

Technical information is located on the internal rating plate.

Environmental Concerns

Disposal of Packing

Packing material is 100% recyclable (♻️ symbol). Dispose of responsibly according to local regulations.

Scrapping the Product

This appliance complies with WEEE Directive (2012/19/EU). Proper disposal prevents negative environmental and health consequences. The symbol ⌽ on the product indicates it should not be treated as domestic waste but taken to an appropriate collection centre for recycling.

Scrapping of Household Appliances

The appliance is made of recyclable materials. Dispose according to local regulations. Cut off the power supply cable before scrapping. Contact local authorities or the store for more information on recovery and recycling.

Energy Saving Tips

• Switch ON the hood at minimum speed when cooking and run for a few minutes after.
• Increase speed only for large amounts of smoke/vapour or use boost speeds in extreme situations.
• Replace charcoal filters for good odour reduction.
• Clean grease filters for good efficiency.
• Use the maximum duct diameter specified to optimize efficiency and minimize noise.

Declaration of Conformity

This appliance is designed, manufactured, and marketed in compliance with: Low Voltage Directive 2014/35/EU; Eco design requirements (EU regulations 65/2014, 66/2014, EN 61591); EMC Directive 2014/30/EU. Electrical safety is guaranteed with correct earthing.

IKEA Guarantee

Guarantee Validity

Valid for five years from the original purchase date from IKEA Pty Ltd or Cebas Pty Ltd. Original sales receipt is required. Service work does not extend the guarantee period.

Service Execution

Service is provided by IKEA Authorized Service Centres. Contact IKEA for details or visit www.ikea.com.au. For Australian customers, specific contact details for IKEA Pty Ltd and Cebas Pty Ltd are provided for different regions (Victoria, NSW, Queensland, Perth, Adelaide).

What the Guarantee Covers

Covers applicable faults due to faulty construction or material from the date of purchase. Applies to domestic use only. Does not cover damage from commercial use. Costs for repairs, parts, labour, and travel are covered if the appliance is accessible for repair without special expenditure. Replaced parts become IKEA property.

Guarantee Conditions

The appliance must comply with technical specifications, assembly instructions, and safety information.

Australian Consumer Law

IKEA's guarantee is subject to Australian Consumer Law. It is in addition to, and does not exclude, statutory warranties.

IKEA's Response

An IKEA appointed service provider will examine the product and, at their discretion, repair or replace it if covered by the guarantee.

What is NOT Covered

Normal wear and tear; deliberate/negligent damage; damage from failure to follow instructions, incorrect installation, wrong voltage; chemical/electrochemical reactions; rust, abrasion, corrosion, water damage (including hard water); damage from misuse; power outages/surges; consumable parts (batteries, lamps, trays); damage from excessive cleaning products; non-functional/decorative parts (scratches, color differences); accidental damage from foreign objects; damage from vermin/insects/pets; internal/external transport damage (must be reported within 7 days); damage to specific parts (ceramic glass, baskets, seals, lamps, screens, knobs, casings) unless due to production faults; cases where no fault is found; consequential loss; repairs by unauthorized providers or with non-original parts; repairs from unauthorized modifications; faulty installation; incorrect venting; non-domestic use; transportation damage by customer; initial installation costs (unless covered by service); statutory rights and remedies.

How Country Law Applies

Entitlement to replacement/refund for major failure, compensation for foreseeable loss. Goods must be of acceptable quality. This guarantee does not limit legal rights.

Area of Validity

The IKEA guarantee applies only to products purchased and installed in AUSTRALIA.

Making a Claim

Contact IKEA Authorized Service Centre. Provide details of the problem, product article number (8-digit code), and date of purchase. Refer to www.ikea.com.au for local service contact information.

Getting Service

The Authorized Service Centre will assist with basic troubleshooting over the phone. Refer to IKEA catalogue or www.ikea.com.au for local store numbers.

Receipt

SAVE THE SALES RECEIPT! Keep the original invoice handy for the service technician as proof of purchase.