GEEKOM Mini PC Installation and Safety Guide

Installation Guide

Step 1: Opening the Case

Illustrates how to open the mini PC case, showing screws being removed and the top cover lifted.

Step 2: Installing M.2 SSD

Shows the process of installing an M.2 SSD. The SSD is inserted into the M.2 slot at an angle and then secured with a screw. The diagram indicates an 80mm M.2 SSD.

Step 3: Installing DDR4 RAM

Depicts the installation of 1.2V DDR4 RAM modules. RAM sticks are shown being inserted into the memory slots on the motherboard.

Step 4: Closing the Case

Illustrates reassembling the mini PC. The cover is placed back onto the chassis and secured, likely with screws.

Step 5: VESA Mounting

Demonstrates VESA mounting. A bracket is attached to the back of a monitor, and then the mini PC is mounted onto this bracket.

Step 6: Connecting Power and Peripherals

Shows the rear and front panels of the mini PC with various ports. It depicts connecting the power adapter to the power inlet and other cables to USB, HDMI, and Ethernet ports.

Port Identification

USB 3.2 Gen2 Port: High-speed data transfer ports.
USB 2.0 Port: Standard USB ports.
+DP Port / USB4+DP Port: DisplayPort or USB4 with DisplayPort support for video output and data.
HDMI Port: High-Definition Multimedia Interface port for video and audio output.
Ethernet Port: For wired network connectivity.
Electric Power Inlet: Connection point for the AC power adapter.
Speaker/Headset Port: For audio output or microphone input.
Power Button/LED: To turn the device on/off and indicate power status.

Safety and Caution Information

AC Power Adapter

[!] Risk of electric shock, fire, or burn if using an AC adapter other than the one provided with this device.
Indoor use only and in dry locations.
Device must only be repaired by a professional. Do not open enclosure.
The adapter is rated for use between 0 °C and 35 °C (32 °F and 95 °F).
Connect only to a properly wired and grounded outlet.
Failure to use the included power adapter shall violate regulatory compliance requirements and may expose the user to safety hazards.

Battery

[!] Risk of explosion if the battery is replaced with an incorrect type.
Batteries should be recycled where possible.
Disposal of used batteries must be in accordance with local environmental regulations.

Temperature

This device is intended for use in ambient temperatures between 0°C and 35°C (32°F and 95°F).
Avoid using or storing next to heat sources, in direct sunlight, or outside the intended temperature ranges.

Medical Devices

This device may interfere with the operation of some pacemakers, hearing aids or other medical devices.
To reduce the risk, maintain a separation distance of 20 cm (8 inches) between the device and the medical device.
Refer to the medical device for additional information.

Modifications

Modification of the wireless solution, thermal solution, device components or enclosure shall violate regulatory compliance requirements and may induce safety hazards.

Regulatory Compliance (FCC/IC)

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and compliance.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation of 5150-5350 MHz is restricted to indoor use.

	GEEKOM XT13 Pro Mini PC User Manual and Technical Specifications User manual and technical specifications for the GEEKOM XT13 Pro Mini PC, including package contents, declarations of conformity, and technical data for Bluetooth and Wi-Fi.
	GEEKOM Mini PC A7 MAX & A8 MAX User Manual User manual for the GEEKOM Mini PC A7 MAX and A8 MAX, detailing setup, components, and safety information.
	GEEKOM A8 Max Mini PC User Manual and Technical Specifications Comprehensive user manual and technical data for the GEEKOM A8 Max Mini PC, including package contents, declaration of conformity, warranty, and disposal information. Learn about its Bluetooth and Wi-Fi specifications.
	GEEKOM A8 Max Mini PC User Guide and Specifications This document provides a comprehensive guide to the GEEKOM A8 Max Mini PC, including setup instructions, specifications, safety information, and compliance details. Learn how to install components like RAM and SSD, connect peripherals, and understand the product's features and safety precautions.
	GEEKOM A Series Mini PC User Guide User guide for the GEEKOM A Series Mini PC, including installation of M.2 SSD and DDR5 RAM, power connection, and safety information.
	GEEKOM A8 Max-R7 Mini PC User Manual and Technical Specifications User manual and technical specifications for the GEEKOM A8 Max-R7 Mini PC, including package contents, Bluetooth and Wi-Fi details, and compliance information.
	GEEKOM A8 Mini PC User Manual and Technical Specifications User manual and technical specifications for the GEEKOM A8 Mini PC, including details on Bluetooth, Wi-Fi, warranty, and compliance.
	GEEKOM A Series Mini PC Assembly and Safety Guide User guide detailing the assembly process and safety precautions for GEEKOM A Series Mini PCs, including models A7 and A8. Features include port descriptions and installation steps for M.2 SSD and DDR5 RAM.