Instruction Manual for AVIANCE lighting models including: 58069, 52159, 45848, 45849, 45798, 45799, 58857, HD74071 6 Light English Bronze Semi Flush Mount, HD74071, 6 Light English Bronze Semi Flush Mount, English Bronze Semi Flush Mount, Bronze Semi Flush Mount, Semi Flush Mount, Flush Mount
1 день назад — Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
ASSEMBLING & INSTALLATION INSTRUCTIONS The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product. HD74071 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR. ASSEMBLING THE FIXTURE (Fig.1) 1. Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box. 2. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation. 3. Thread the two mounting screws about 1/4" into the pre-drilled holes in the mounting plate spaced the same distance apart as the holes in the canopy (B). Attach the mounting plate to the Junction Box with the two Junction Box Screws as shown. The side of the mounting plate marked "GND" must face out. The junction box is not included. FIG.1 Green Screw (GND) Junction Box (Not included) Mounting screw Junction Box (Screw) A B C D E 4. Attach the tube(F) to the top center coupling of the lamp holder(G), turn it until tighten. Raise the pipe thread(D) to the top coupling of the shade(E), turn it until tighten, Using the same method install the others pipe. Raise the canopy(B) onto the end of pipes, aligning the mounting holes, lock it securely with the lock washer and hex nut(A). Now, catch the lamp holder's wires, then through the shade's center hole and canopy's center hole, by turning it clockwise until tight. NOTE: THE SHADE(E) OF THE PRODUCT MAY VARY. G F H I 5. Thread the pipe(H) into the bottom center coupling of the lamp holder and lock it securely with the hex nut. Raise the steel shim (I), acrylic plate(J) and steel shim(K) to the bottom of the shade (E), lock it securely with the finial (L). 6. Install the light bulbs(not included) in accordance with the fixture specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE! 7. While holding the shade assembly towards the ceiling, connect the electrical wires as Shown in Fig.2, making sure that all wire nuts are secured. You may have to wrap the connections with electrical tape. If your outlet has a ground wire (green or bare copper), connect the fixture ground wire to it. Otherwise connect fixture's ground wire directly to the mounting plate with the green screw provided. After wires are connected, tuck them carefully inside the Junction Box. 8. Raise the shade assembly onto the junction box, aligning screws on mounting plate with mounting holes in canopy (B) and lock it securely with the column nut (C). Your installation is now complete. Return power to the junction box and test the fixture. J K L FIG.2 FIXTURE WIRES Black or Smooth FIXTURE WIRES White or Ribbed HOUSE WIRES Black(Hot) HOUSE WIRES White (Neutral) FIXTURE WIRES Bare Copper (Ground) HOUSE WIRES Green or Bare Copper(Ground) ` Thank you for purchasing an AVIANCE product. Need assistance with parts or assembly? Please email customer service at:info@aviancelighting.net ©COPYRIGHT ALL RIGHTS RESERVED. AVIANCE LIGHTING,INC. DOC202503HD74057Acrobat Distiller 9.3.2 (Windows)